General Information; Assembly And Installation - OSRAM DALI LS/PD LI Installation Und Betriebsanleitung

DALI LS/PD LI, Installation + Operation

1 General information

1.1 Symbols and abbreviations used in this manual
• Bullet point, listing
1. Numbered steps in specified order
2.2
 Reference to section (e.g. 2.2.) or separate manual (without number)
13
Figure reference (e.g. to Fig. 13)

Abbreviation for "Short Press / Press button briefly" (<0.5 s)
SP
VLP "Very Long Press / Press button for very long duration" (>10 s)
1.2 Intended use
This product is specially developed and intended for use with light management systems for
lighting systems. Any use other than that described in this instruction manual is not as intended.

2 Assembly and installation

2.1 Sensor and networking 4

Names of individual components 3a

(1) LED display
(2) Sensor button (recessed in housing)
(3) Presence sensor
(4) 2 Shutter (set detection range/presence)
(5) Sensor housing
(6) DALI line connection
(7) Cover
(8) Brightness sensor
(9) Retaining lugs
Connection of multiple sensors via DALI to the control unit
2.2 Connection
Connection of the sensor cable (DALI line) between control unit and sensor
2.3 Assembly options for the luminaire
There are 2 different covers for this as well as the possibility of individually fitting into the lumi-
naire housing:
• Cover (2) for installing the sensor externally through the opening (1) in the luminaire housing
3c . The cover is placed on the sensor prior to installing the sensor and the two together

are inserted in the opening in the luminaire housing.
•
Cover (2) for installing the sensor internally
ing. If the sensor is in the correct mounting position, the raised surface of the cover will sit
flush in the luminaire opening (1).
• Internal sensor installation without separate cover
The openings in the luminaire housing (1) must be made to accurately fit with the sensor (2).
Retaining lugs (9) on the bottom of the sensor for simple assembly on corresponding
counterpart 3a .

2.4 Assembly-location
6

5 .

4 .

3d . The cover is placed on the sensor hous-

3b .
