Maintenance - Jydepejsen ELEGANCE JUNIOR Befeuerungsanleitung

Stoking
1. Position the air wheel in click 5 (maximum air).
2. Leave the door ajar for about one minute before you open it fully in order to minimise the low pressure.
3. Open the door slowly.
4. Place 2 or 3 pieces of wood into the fire chamber. (The test results have been achieved by placing the wood pieces
lengthwise, behind one another).
5. Close the door.
6. Place the air wheel in click 4 or further down once the firewood is properly ablaze.

5. Maintenance

Sealing band and vermiculite panels are wearing parts which need to be renewed. How often this is needed depends
on how much you use your stove. In some cases every year, others every second or third year. A principal rule is that
the sealing band needs renewal when it is flattened, and the door no longer fits tightly against the front of the stove. A
new set of sealing band with glue can be purchased from your local dealer.
Vermiculite panels must be renewed when they are worn thin, or when possible cracks are so wide that you can actu-
ally see steel through them. If the panels are not renewed on such occations, they lose their power of insulation and
heat reflection. Movable and mechanical parts should be greased once a year with a heat-resisting lubricant (closing
mechanisms, hinges etc).
Renewal of the sealing band at the door
1. Remove the sealing band from the inner frame and clean the band mark (it is not necessary to remove the door
from the stove).
2. Add a band of heat-resistant glue on the band mark.
3. Push new sealing band down into the mark.
4. Close the door and let the glue harden for about 24 hours, before you open the door again. If you do not let the
glue harden sufficiently before you open the door, the band may fall out.
Renewal of the sealing band at the Glass
1. Dismount the screws on the door.
2. Lift off the glass.
3. Remove the old sealing band from the glass.
4. Add new sealing band to the glass.
Re-mounting of the glass takes place in the opposite order.
Change of the vermiculite panels
1. Place the rear panel.
2. Place the side panels.
3. Place the bottom panel.
4. Place the baffle plate on top of the rear panel/side panels.
Change of the vermiculite panels takes place in the opposite order.
[GB 5]