Hama 62426 Einbauanleitung Seite 3

Komfort CAN Bus Interface 62426 Installation Instructions
Interface for connecting retrofitted car radios and navigation systems to the interior or Komfort CAN Bus
directly in the radio slot. Suitable for reading the speedometer signal, terminal 15 ignition, lighting and
reverse gear signal.
No need to search for the CAN signal in the engine compartment!
Important note: Before you install the interface:
The Komfort CAN Bus interface reads data from the CAN protocol of a vehicle. Installation in a vehicle,
which should be done by an expert, involves intervening in a complex overall system, with which we,
as supplier of the abovementioned assembly are insufficiently familiar. Please always observe the
installation guidelines and guarantee conditions of the vehicle manufacturer when installing
electronic assemblies in vehicles. You must always inform the owner of the vehicle that an interface is
being installed and point out the risks to them. We recommend that you contact the manufacturer of the
vehicle or a licensed garage to avoid risks.
Ready to plug in for all navigation devices by Becker, JVC KD-NX 1 F,
Sony MEX 100, Pioneer ANH-P 9 R and VDO Dayton MS 4150
for: VW Touran
Connection sequence:
➄
➃
➁
➂
➀
1. Connect the large multi-connector ➀ to the connector in the vehicle.
2. Connect the black 8-pin ISO connector ➁ to the navigation device (chamber A).
3. Connect the brown 8-pin ISO connector [speaker] ➂ to the navigation device.
4. The loose cables ➃ of connector ➁ are used to transmit the telephone mute signal to your telephone
system, if required. See assignment below.