Operational Instructions; Bluetooth Mode - Wiko WiSHAKE SP Bedienungsanleitung

OPERATIONAL INSTRUCTIONS

1. Power On/Off: Press and hold the spin button for 2 seconds
2. Volume up: Rotate the spin button clockwise.
3. Volume down: Rotate the spin button anti clockwise.
4.
Music Play/Pause when Bluetooth is connected: Press the spin button once.
5. Enter Pairing Mode: Quickly press spin button twice. The LED flash white to indicate the
paring mode.
6. Low Power Indicator: A beep sounds once every minute.
7.
The white LED stays lit when the WiSHAKE is charging and switch off when
is full charging.
AUX INPUT MODE
1. The AUX input is available only when the Bluetooth is paused or disconnected.
(4 seconds for android devices and 8 seconds for iOS devices after pausing)

BLUETOOTH MODE

1. To connect WiSHAKE, keep it in the pairing mode, start Bluetooth searching on your
device and click "WiSHAKE SP» in the search result list. If it requires a pin code,
please input 0000.
2. The Bluetooth takes priority over AUX when both audio sources are connected.
3. WiSHAKE automatically searches and connects with previously paired devices when it is
turned on. If search fails, then WiSHAKE automatically enters the pairing mode shown by
a flashing white LED.
4. The WiSHAKE automatically enters the idle state when it stays unconnected for
15 minutes in the pairing mode and the led slowly flashes white.
EN