SLV 229453 Gebrauchsanweisung Seite 2

ENGLISH
Instruction Manual
for LED RGB Outdoor Light
229453
Please read carefully and keep for further reference !
1. Use as directed:
This product serves exclusively lighting purposes and may:
only be operated using a suitable controller(output current: 350mA
constant, e.g. art.-no. 470523/24).
not be exposed to strong mechanical loads or to strong contamination.
only be installed and operated after a condition inspection if the product
is dirty or has been moistened through storage.
not be modified or converted.
If these points named above are not adhered to, a short circuit or
electrical shock may occur!
2. Technical Data:
Operating current: 350mA
Safety class: III
Safety type: IP 65
Bulb: 15x 1W POWER LED, 350mA
Dimensions (W/H/D): 17/18/6 cm
Swivel range: 360°
Weight: 1,75 kg
Importeur: SLV Elektronik GmbH
IP 65: Protection against dust(dust-tight) - Protection against jetted water
from all directions
3. Installation
The complete installation must be done by an electrical expert,
who is familiar with the valid directives.
Attention: Switch off power of the mains supply or respectively of
the connection lead before doing any works. Use only parts, which are
supplied with the product or are described as accessories! Otherwise the
product or the installation might not be sufficiently safe!
Indication for the installer: In case you do not install a completely
supplied system (with transformer), you are considered a "manufacturer" by
the low-voltage directive. In this case you are required to ensure the
conformity of the whole system and declare it by attaching the CE-sign.
Installation place:
The product is suited for wall-, ceiling and floor installation.
Make sure that the product is mounted on a stable, even and tilt-fixed
background.
Separate Assembly Steps
Keep the whole installation off power until the work is completely
finished. A connection with the power on will destroy the LED.
Fixation
Determine the place of installation and mark and drill the holes for
fixation. Fasten the fitting on the installation surface using properly
dimensioned fastening materials that suit the installation surface (1).
Ensure the secure hold of the product!
Connection
Outdoor installations must comply with valid regulations for this kind
of installation area!
Fig. 1 shows a connection diagram using the LED RGB controller (art.-
no. 470523). Note the instructions!
Use an outdoor connection box(e.g. SLV-art.-no. 228725 ) to connect
the product.
The product is ready for operation after all connections are established.
4. Operation
:
Information for the user:
Operate the product only if it is working correctly. Switch off the product
with a malfunction immediately and operate it again only after examination
by an electrical specialist. This is the case, when:
visible damages appear.
the product does not work.
smoke, steam or crackling sounds appear.
an overheating is recognisable.
Repairs of the product or work on mains voltage-prominent sections may
only be carried out by qualified electricians.
Attention: Here exists mortal danger from an electric shock!
How to avoid failure and fire risk:
Do not cover the product - provide free air circulation!
Do not hang or fasten anything on the product, especially no decoration.
Never let children play unsupervised with electric products! Children
can not always estimate dangers in dealing with electric energy correctly.
ATTENTION! The following enviromental influences may have
unwanted effects on the surface of the product:
acid rain and sour soil high salt content in the air
thawing salt cleaning agents
other chemical substances (e.g. herbicides)
Protect the product by adequate means to avoid unwanted changes of the
surface. Cleaning tip: Switch off power! Clean the product with a damp
cloth.
What is to do if a bulb is defect or does not work?
Under regular usage the LED bulb has an extraordinary long lifetime. If
nevertheless damage or failure occurs, contact your local dealer.
5. What else has to be considered?
Disconnect the product from power, before you...
clean or maintain the product.
do any works on the product or its components (electric expert).
02/2007 © by SLV Elektronik GmbH
229453
Technical Details are subject to change. Duplication prohibited !
470523
R- G+
G- B- B+ R+
R- B- G+
G- B+ R+
1
228725