Maintenance - Nemesis FNU200 Montageanleitung

INSTALLATION (CONT.)
Try to gauge the amount of gap and add the necessary amount of 1mm thickness Spacer Rings (5) between
the Shield Plate (1) and the Lock Unit (3) as shown in Fig.A.
If you add too many Spacer Rings (5) it will not be possible to fully engage the Lock Unit into the Receiver
Bolt and rotate the key to lock it. If this happens then simply remove one Spacer Ring at a time until you
achieve a secure fitment.
Once satisfied with the fit between the Shield Plate (1) and the face of the wheel, the Spacer Rings (5) can
be retained in place by securing the Lock Unit (3) to the Shield Plate (1) by tightening the Lock Unit Hex
Screw (6) using the supplied 3mm Hex Key (7).
4.
The Nemesis Ultra is now ready for use. Please check the Receiver
Bolt torque setting after the first 100 miles (approx) and at regular intervals
thereafter.

MAINTENANCE

Fit protective Lock Cap (9) over shield plate (1) to help prevent ingress of dirt or water.
Grease the lock face and ball bearings before first use, with a light oil such as 3-IN-ONE or equivalent.
Thereafter spray any moving parts of the lock body with a light oil such as 3-IN-ONE or equivalent every
eight weeks.
Please store your keys in a safe place and remember to register your product. Your key number is located on
both of the keys supplied and will be required in order to purchase replacement keys.
Registration is quick and simple, go to www.purpleline.co.uk/product-registration
Please register within 14 days of purchase. Please retain your original purchase receipt.
FNU200 User Manual Page 4 UK
4