Hydro Mousse Gebrauchsanleitung Seite 9

APPLICATION
1. Preparing the planting surface (Figure 1)
• Remove dirt and dry grass.
• Loosen the top soil layer with a rake.
Helpful tips prior to sowing:
• Loosen the earth prior to applying the Hydro Mousse™ System in order to ensure a perfect new lawn
• Initially apply Hydro Mousse™ System using water alone (without seeds carrier), in order to get a feeling of
how it works.
• Turn switch (B) to OFF (0), prior to starting the next step.
2. Preparing the Hydro Mousse
• Fill the seed canister (D) with all of the seed mixture (F). Do not fill beyond the maximum fill level.
• Open the carrier pouch (E1) and remove the carrier tablet (E2). Place the carrier tablet (E2) with the
water-soluble film in the seed canister (D).
• Attach the Hydro Mousse™ Spray and seed attachment (A) to the seed container (D) and screw it tight.
Ensure that the switch (B) is in the OFF position (0).
• Then attach the garden hose und turn on the tap.
3. Applying Hydro Mousse
• Turn the dial (B) to „Heavy sowing" (
king on the canister). Please note: At this point, clear water will flow from the spray head. This is completely
normal. The canister is automatically filling with water at the same time! Thereafter, turn the selector dial to OFF
(0). The tablet will immediately begin to dissolve.
• Decide upon the area that you would like to grass.
A tip from us: We recommend shaking the canister once it has been successfully filled with water.
This is so that the water then mixes even better with the seed mixture and the carrier!
• Now turn the dial (B) to „Light sowing" (
– for first-time grassing). After a short time, green liquid mixed with seed mixture should flow from the spray
head. It may be that clear water continues to flow in the first few seconds before the liquid turns green.
• Spray on the ground evenly and briskly from a distance of around one metre. Depending on the water pressure
in your pipe, you now have approximately 4 minutes to administer the seed mixture and the carrier.
Caution: After this period, it may be that the liquid is still green, but that there is no more seed mixture.
As soon as green liquid flows from the spray head without any seed mixture, stop application and turn the
selector dial to the OFF position again (0).
• Normally, no seed mixture should now remain in the canister. In the event that there is still some seed mixture
in the canister, you can briefly continue application with the inverted canister and with the spray head turned
on until the residual seed mixture is released from the canister.
4. Watering the area planted (Figure 4)
• Water the ground three times a day in order to keep the surface moist until the lawn attains a height of around
7 cm. Turn the switch (B) to "watering" (
Helpful hints:
• The seeds will begin to germinate in around 7 to 14 days.
• Start mowing after the lawn attains a height of around 7 cm.
• Plant a new lawn between March and October.
• Screw the spray and seed attachment (A) on tight.
• The carrier (E2) contains a water soluble non-dying colouring.
• KEEP THE SEED CONTAINER FOR REFILLING / REUSE!
(Figure 2)
TM
(Figure 3)
TM
) and fill the seed canister (D) with water until it is 3/4 full (see mar-
) ( – for re-seeding or for lawn repair) or „Heavy sowing" (
).
EN
9