Speaker Connection; Operation - WJG McVoice AMP-510 Bedienungsanleitung

Speaker Connection:

• While using 2-way-speaker the impedance should not be lower than 8 Ω per speaker. Otherwise the
speakers could be damaged.
• Pay attention to the correct polarity while connecting the speakers.
• Pay attention that dismantled wires don't have contact with each other.

Operation:

•
After connecting the speakers to the amplifier plug the power supply cable [5] into an electric outlet.
• Switch on the amplifier with POWER [3] then the display [14] will be illuminated.
• Use INPUT [10] and choose a signal source.
• Use MASTERVOLUME [15] to control the main volume.
• Use DSP [4] to choose from different sound settings.
• Use VFD [7] to choose from different display settings.
• If a signal source is connected to AC-3/DTS INPUT [2] and all speaker outputs SURROUND SPEAKER &
MAIN SPEAKER [4] are allocated use the keys [5] for adjusting the desired ambient sound.
• In an ambient sound system control the volume of each speaker with the keys [6].
• Use MUTE [2] for stop the complete signal output without switching the amplifier off.
• Use OK [5] for activating the karaoke mode including the microphone input MIC1/MIC2 [12]. To control
the volume of the microphone signal use MIC.VOL [1]. In addition the echo and the delay function
ECHO+/- and DELAY+/- [9] are active.
P2009 © Firma WJG, Braunschweig. Nachdruck oder Vervielfältigung nur mit ausdrücklicher Genehmigung
863-675/-676