Herunterladen Diese Seite drucken
JULIEN HOOGSLAPER
Hochtbett • Lit Sureleve • Loft bed
loading

Inhaltszusammenfassung für Woood JULIEN

  • Seite 1 JULIEN HOOGSLAPER Hochtbett • Lit Sureleve • Loft bed...
  • Seite 2 BELANGRIJK – LEES AANDACHTIG DOOR – BEWAAR VOOR LATERE RAADPLEGING NEDERLANDS Dit product is geproduceerd overeenkomstig veiligheidsvoorschriften NEN EN-747-1+A1:2015 Waarschuwingen Monteer het bed zorgvuldig volgens de instructies in de meegeleverde handleiding. Wijzig niets aan de vormgeving en de montage van dit bed. Alle meubel verbinders moeten worden gebruikt en vastgedraaid Matras De dikte van de matras moet zodanig zijn dat afstand tussen de bovenzijde van het matras en...
  • Seite 3 IMPORTANT - READ CAREFULLY - RETAIN FOR FUTURE REFERENCE ENGLISH This product is manufactured in accordance with safety regulations NEN EN-747-1+A1:2015 Warnings Assemble the bed carefully following the instructions in the manual. Do not change the design and installation of this bed. All the furniture connectors must be used and tightened Mattress The thickness of the mattress must be such that distance between the top side of the mattress and the upper side of the edge of the bed is at least 16 cm.
  • Seite 4 WICHTIG - LESEN SIE AUFMERKSAM DURCH- FÜR SPÄTERE VERWENDUNG AUFBEWAHREN Deutsch Dieses Produkt wurde entsprechend den Sicherheitsbestimmungen NEN EN-747-1+A1:2015 hergestellt. Warnhinweis Montieren Sie das Bett indem Sie sorgfältig den Anweisungen im Handbuch befolgen.Konzeption und Montage am Bett nicht ändern. Alle Möbelverbinder müssen verwendet und festgezogen werden. Matratze –...
  • Seite 5 IMPORTANT - À LIRE ATTENTIVEMENT - CONSERVER POUR RÉFÉRENCE FUTURE FRANÇAIS Ce produit est fabriqué conformément aux normes de sécurité NEN EN-747-1+A1:2015 Avertissements Assemblez le lit en suivant attentivement les instructions dans le manuel. Ne pas changer la conception / le dessin et l'installation de ce lit. Tous les connecteurs du meuble doivent être utilisées et serrées Matelas L'épaisseur du matelas doit être telle que la distance entre la face supérieure du matelas et la partie supérieure du bord du lit est d'au moins 16 cm.
  • Seite 6 24mm Ø15 8x25 8x35mm 8x50 LIJM M6x55 SW 4 3,5x35 4,5x40 M6 Ø7x67,5 M6xØ10x13 Ø10x12,5 M6x8 SW3 SW 3 5x50 7x50 M6x50 M6 Ø8x12 76x31x16mm...
  • Seite 7 4x20...