Controller; Options - Hettich HS1286 Bedienungsanleitung

3.2

Controller

Type:
Case:
Material:
Dimensions:
Front panel:
Material front:
Range:
Voltage:
Connected load:
Operating temperature:
Storage temperature:
Operating humidity:
Accuracy:
Status LED's:
Alarm LED's:
Buttons:
Input temperature sensors:
Digital input:
Interface:
Relays:
Battery loader internal:
Battery:
3.3

Options

The listed options are available:
− Storage racks for upright and chest models (Stainless steel)
− Polypropylene box with separated partitions
− CO backup cooling system
2
− Software archiving system
− Temperature recorder
− Monitoring software
ST9002
Steel panel
Steel Grey coated
217 x 155 x 85 mm (wxhxd)
min. 208 x 146 mm (wxh)
Polycarbonate (IP-44)
-100°C / +25°C
230 Vac; 50/60 Hz (220 - 10% / 230 + 5%)
9VA
-20°C/ +50°C
-20°C/ +60°C
10 % / +90 % Relative humidity, not condensing
± 0,5 % of the working temperature range
COOL = relay cooling on
BACKUP = CO backup cooling on
2
BATT.LOW = battery empty
HIGH = Warm alarm (e.g. - 50°C)
LOW = Cold alarm (e.g. - 90°C)
ON/OFF = ON/OFF button
+ = increase button
- = decrease button
PROG = Program button with led
CODE = Access code button with led
SETP = Set point button
BATT. = Battery state button
PT1000 2 wire (DIN/IEC 751)
Door contact
RS 485
RY1 = Alarm
RY2 = Backup cooling
RY3 = Cooling
RY4 = Fan
RY5 = battery contact
RY6 = Alarm relay (telephone relay)
ca. 50 mA
Lead battery 1.2 Ah (protected by fuse F1.2A)
EN
15/19