Mitsubishi Electric MSZ-LN Series Konfigurationshandbuch Seite 5

2-3. Setting up in WPS-PUSH mode
1. Make sure that the LED indication is as shown below.
Push WPS button of the Router within 2 minutes after the mode selection
in 2-2. has completed.
The WPS-PUSH mode will return to initial state in 2-1. if WPS button is
not pressed for 2 minutes.
LED indication
2. LED indication will be as shown below when connection between the Router
and Wi-Fi interface is completed and connection to MELCloud starts.
Note: LED indication will return to initial state in 2-1. if the connection fails.
LED indication
3. LED indication will be as shown below when the connection is completed.
Note: It may take several minutes to show the indication below.
LED indication
Main Causes that WPS failed are as follows.
Communication distance (from the Wi-Fi interface to Router), Router settings (encryption,
authentication, limit of connections, etc.)
For more information, refer to Troubleshooting in 3. LED Pattern.
Flash (every second)
ON (5 sec)
Flash (every 5 sec)
Flash (every 5 sec)
Connecting
Router
Connected
Connecting
MELCloud
Connected
Connected
Wi-Fi Interface
GB-4