Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6. Installation walk-on version
Excavation pit: Care must be taken to avoid damage to existing pipework, vegetation or
buildings, when installing the MAXI filter. The latter is especially important when there is
a deep installation of the MAXI filter.
Filling material: The filling material should be load-bearing, well compacted, frost free,
ideally this would be a wide-graded sand-/gravel mixture (e.g., grain size 0/32). Do not
backfill with material such as topsoil, rubble or clay soil. Excavated soil can only be used
if it corresponds to the above mentioned criteria.
Connection pipes - it is very important that the outflow pipe has an incline equal to or
greater than the incline of the inflow pipe to the filter. Failure to observe this will cause
the filter to back up/overflow during heavy rainfall. This also applies to the auxiliary
overflow.
Installing the MAXI Filter
1. Excavate the hole.
2. Lay a 100 mm thick bed of filling material,
compact it well (machine, or three operations
with hand tamper 15 kg / squared timber or
similar)
3. Insert and adjust the filter, attaching the
pipe connections.
4. Fill in the filling material in about 100 mms
thick
layers.
The
material around the filter body should be about
100 mms. The rest of the layer can be filled
with excavated earth. Every layer has to be
compacted, e.g. with a hand tamper 15 kg /
squared timber or similar mechanical device.
This kind of filling should be carried out up to
100 mms from the top edge of the ground.
5. The rest filling can be chosen arbitrarily
Technische Änderungen und Rechte vorbehalten. Keine Haftung für Druckfehler
Die Inhalte der technischen Dokumentation sind Bestandteil der Garantiebedingungen
The contents of the technical documentation are a component of the guarantee terms
Es sind bei Planung und Einbau die einschlägigen Normen und andere Regelwerke sowie die Unfallverhütungsvorschriften zu
Planning and installation regulations are to be followed, as well as the accident prevention regulations.
Maxi Plus
thickness
of
the
filling
REWATEC GmbH März 2014
Technical changes and rights reserved. No liability for misprints
beachten.
DORW2107
A Filling material according to point 6
B Filling with excavation or similar
C upcoming ground
09.03.2014
9 / 9
Werbung
