Electrical Connection - AEG Electrolux KD81403E Installationsanleitung

Installation instructions

Electrical Connection

Electrical installation must be performed by an
electrician qualified in accordance with the
legislation in force.
Before connecting the crockery warmer to the
electric mains, check that the voltage and
frequency of the mains matches that which is
shown on the rating plate located in the heating
block inside.
The electric connection is made via an omnipolar
switch, which is suitable for the intensity to be
tolerated and which has a minimum gap of 3mm
between its contacts,
disconnection in case of emergency or when
which will ensure
cleaning the crockery warmer. If a plug is used for
the electric connection, then it must be accessible
after installation.
The connection should include correct earthing, in
compliance with current norms. WARNING: THE
CROCKERY WARMER MUST BE EARTHED.
If the flexible supply cable fitted to the crockery
warmer ever needs to be changed, it should be
replaced by an official After Sales Service,
because it requires special tools.
The manufacturer and retailers do not accept
responsibility for any damage that may be
caused to people, animals or property if these
installation instructions are not observed.
EN
16