"Uv" Authentication; "Wm" (Fluorescent Light) Authentication; "Mg" Authentication; External Magnifier - Pro Intellect Technology 1500 Ir Gebrauchsanweisung

5
for PRO 1500IRPM
Connect the supplied adapter to the power input port and switch the device on. Press
the "UV/WM" button and the corresponding indicator will light up.
Place the banknote under the UV light (fig. 1.7) and the UV light (located in the top
cover) will turn on automatically.
Under UV light, banknote paper should not glow. Counterfeit banknotes printed on
common (non-official) white paper will glow brightly under UV light. However, it should
be noted that the same glow can be seen when authentic banknotes have been exposed
to certain environments, especially laundry detergent or bleach.
If the banknote has suspicious UV properties, further verification is necessary.
The UV light will turn off automatically after 5 minutes.
6
for PRO 1500IRPM
Press the "UV/WM" button and the corresponding indicator will light up. Place the
banknote on the working table (Fig.1 pos.4) over the auto start sensor and the
fluorescent light will turn on. Check for the presence of watermarks, evidence of erasure
or other damage, continuity of lines and microprinting on the banknote.
7
for PRO 1500IRPM
Push the "MG" button and the corresponding indicator will light up. Press the banknote against
the magnetic sensor and move it back and forth. The presence of a magnetic mark will be
indicated by a sound and blinking of the green magnetic sensor indicator (fig. 2, pos.3). This
process tests for the presence of magnetic features at currency-specific locations.
Additionally, banknotes should be tested for the presence of magnetic features where none
should be detected (for example, on the Federal Reserve mark on USD). If the device makes
no indication during this process, the banknote can be considered authentic.
Attention! It is possible to imitate magnetic ink by spreading magnetic substances on the
surface of a banknote. Such banknotes may result in a positive indication of magnetic
substances where none should be detected.
Attention! Some types of copiers, laser printers, and other imaging devices can contain
magnetic substances that will leave magnetic markings on banknotes.
8
Connect the magnifier's power cord to "OUT DC 9V" jack. Press the power button (left).
Place the magnifer on the banknote and check for continuity of lines, anti scanner net,
and micro text. One can also use the magnifier with batteries (AAAх2) to work independ-
ently of the main device.
12

"WM" (fluorescent light) Authentication

"UV" Authentication

"MG" Authentication

External Magnifier