Werbung
ENGLISH
6
BlueBus photocell routing
PHOTO
External photocell h = 50 activated on closing
PHOTO 1
Internal photocell h = 50 activated on opening and clo-
sing
Recognition of the devices connected to the
7
BlueBus and Stop input
01. Press and hold down and "Set" keys at the same time. Release the two keys
when LEDs "L1" and "L2" start flashing quickly (after approx. 3 seconds).
02. Wait a few seconds for the control unit to complete the device learning phase.
03. At the end of this phase, the "Stop" LED must be lit while LEDs "L1" and "L2"
must turn off (LEDs "L3" and "L4" may start flashing).
Learning the positions of the
8
mechanical stops
01. In Table A, identify the configuration that corresponds to the one of your installa-
tion and note the position envisaged for electric jumpers JA and JB. Then, on the
control unit, insert the electric jumpers in the same position observed in Table A.
02. Release the gearmotors by means of the special keys and move the leaves to
mid-travel so that they are free to move in the opening and closing directions;
then lock the gearmotors.
03. On the control unit, press and hold down and "Set" keys and release them as
soon as LEDs "L3" and "L4" start flashing quickly (after approx. 3 seconds).
04. Wait for the automation to carry out a series of manoeuvres. After these have
been completed, LEDs "L3" and "L4" turn off to indicate that the procedure was
performed correctly. Caution! – Refer to the manual if the manoeuvres are not car-
ried out or the LEDs do not turn off.
9
Basic operation
At this point the automation is ready to work with the factory settings.
Whereas if you want a customised operation it is necessary to consult the "
struction manual to learn how to activate or deactivate the desired functions and how
to change the factory values of the various parameters.
8
EN - Table A
IT - Tabella A
FR - Tableau A
B
A
A
B
B
B
A
EN
- leaf surmounting the other leaf
IT
- anta che sormonta l'altra anta
FR
- vantail surmontant l'autre vantail
ES
- puerta que sobrepasa la otra puerta
DE
- Flügel, der über den anderen Flügel geht
PL
- skrzydło zachodzące na drugie skrzydło
NL
- vleugel die boven de andere vleugel komt
B
EN
- gearmotor with control unit
IT
- motoriduttore con centrale di comando
FR
- moto-réducteur avec centrale de commande
ES
- motorreductor con central de mando
DE
- Getriebemotor mit Steuerung
PL
- motoreduktor z centralą sterującą
NL
- reductiemotor met besturingssysteem
" in-
ES - Tabla A
PL -
Tabela A
DE - Tabelle A
NL - Tabel A
B
A
A
B
B
B
Werbung
