Seite 2
7040 0900 0000 Vorbereitung / Preparation V-Port ausfahren, Kabel mit Steckmodul anschließen / Slide down the V-Port and insert the mains connector Variante A - Wandmontage / Wall mounting Je nach räumlicher Gegebenheit / Depending on the installation area conditions rechts montieren / links montieren / nicht beidseitig montieren / right hand side mount left hand side mount do not screw both sides invented and made by Schulte Elektrotechnik, Lüdenscheid, Germany.
Seite 3
7040 0900 0000 Variante B - Montage unter dem Oberschrank / Mounting underneath overhead cabinet / Zusätzlich mit Klebeband an der Wand fixieren. Beim Herausziehen von Steckern den V-Port festhalten / Alternatively the V-Port can be mounted by using double sided tape. Whilst pulling out a plug, hold the V-Port in place. 2 Streifen Klebeband mit je 35 x 220 mm rückseitig aufbringen / Attach 2 adhesive strips 35 x 220 mm to the back Montage der Edelstahlblende / Stainless steel cover mounting Blende in den Profildeckel einführen, andrücken und in den unteren Profilabschluss ziehen. / The profile lid can be installed by placing the lid in the notch as shown in the diagram below, then positioning the lid over the bottom notch and sliding it down. invented and made by Schulte Elektrotechnik, Lüdenscheid, Germany.
Seite 4
7040 0900 0000 125 mm Steckdosen* 3 Steckdosen bzw. 2 Steckdosen und USB Charger* sockets* 3 sockets and 2 sockets with USB charger* 125 mm 125 mm Länge abweichend bei Steckdosen UK / Length will vary with UK sockets / invented and made by Schulte Elektrotechnik, Lüdenscheid, Germany. 7040 0900 0000 1402 a...