Tips And Troubleshooting - Inline 99140I Bedienungsanleitung

9. Tips and troubleshooting

www.inline-info.com
selected.
Step 6:
Now the music from your smartphone / tablet can be played in your audio hi-fi
system.
Disconnect the active connection:
Double-clicking the Power / Pair button disconnects the Bluetooth receiver
from the paired device, and the receiver switches to pairing mode and the LED
flashes. If no new connection is established, the receiver switches into
standby after 2 minutes.
The connection can also be disconnected via the device settings of the
smartphone.
Connect other devices to the Bluetooth receiver:
The InLine® Bluetooth True Hi-Fi audio receiver can remember the connection
of up to 8 playback devices and connects without a new pairing process.
To connect other devices to the receiver, first disconnect (if present) the active
connection to the device by a short double-click on the power / pair button, the
receiver will now automatically switch to the pairing mode. Repeat the above
steps 3 to 6 with the new device.
Switch connections between devices:
By double-clicking on the Power / Pair button, the connection to the next
device can be established. While the receiver is flashing, connect your already
paired smartphone and you can play your music.
Standby and switching on the receiver:
If the receiver's power / pair button is pushed for 4 seconds, the receiver
switches to standby mode. Pressing it again turns the receiver back on and it
is ready for the new connection. If the connection to the last connected device
is possible, this is established automatically.
Reset:
To reset the InLine® Bluetooth True Hi-Fi Audio Receiver to factory setting
follow following instruction: After the receiver is powered on, press and hold
the power / pair button for approx. 10 seconds until the indicator lights up
slowly. The receiver now loses all known connections to already paired
devices and must be reconnected if necessary.
The receiver is connected, but the LED does not light:
Check whether the receiver is connected to a suitable power supply, the USB
power supply should provide at 5V minimum 200mA, better 500mA. Possibly
the USB cable used has a cable break, replace the USB cable.
My smartphone does not pair with the receiver:
Make sure the receiver is switched on, the LED flashes, and the receiver is
within 30m of the smartphone. Disconnect the receiver from the USB power
for a short period of time or turn off Bluetooth on your smartphone and then
turn it on again. Then try to reconnect.
Page 5 of 7