Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Packing List
Before you start installing GSW-0890 8-Port Gigabit L2 Managed Switch, please
verify that the package contains the following items:
GSW-0890
-
Power Cord
-
RS-232 Cable
-
User Manual in CD-ROM
-
Please notify your sales representative immediately if any of the aforementioned
items is missing or damaged.
Power Requirements
AC Line, Voltage100~240VAC, Frequency 50~60 Hz, Consumption 13W
Quick Installation
1.
Install the switch in the rack with mounting accessory.
2.
Connect the switch to an AC power source.
3.
The port 1-8 connector is RJ-45 jack on the switch. Use Category 5 UTP
cable to connect between the switch and end station.
4.
The port 7, 8 includes two types of media --- TP and SFP fiber module; they
support TP or fiber with auto-detected function.
5.
Use RS-232 interface to pre-configure the switch for network management.
For example: IP address, VLAN, Port Trunking, STP, etc.
Serial Port Default Settings
Baud rate 57600, Stop bits 1, Data bits 8, Parity N, Flow control none
Web Admin Default Settings
IP Address : 192.168.1.1
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.1.254
Username : admin
Password : admin
Note: Web GUI can only access by TP Port7 and Port8
User also can use telnet or web to pre-configure the switch with the default IP
address and username/password in the first configuration. Please refer to User
Manual contained in CD-ROM for details on the setting of parameters.
GB
Werbung
