Herunterladen Inhalt Inhalt Diese Seite drucken

Standby-Modus; Residual Heat Indicator; Safety Systems - Philips HC-3402 Gebrauchsanweisung

Cerankochfeld
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Stand-By-Modus
Press the On / Off button. You will hear a beep and see flashing lines on the display at the upper and
lower plate.
If you have not selected a program within about 2 minutes, the unit will return to standby.
Power
Press the button
for the left cooking zone or button
for the right cooking zone.
With the buttons „1-9" you can change the power levels or by pressing the "0", switch off the relevant
cooking zone.
Left cooking zone up to max. 1800W
Right cooking zone up to max. 1600W

Residual heat indicator:

When the hob has been operating for some time, there will be some residual heat.
The residual heat indicator warns for each cooking zone separately with "H" symbol.
Timer
After you have selected the power press the timer key
.
Timer confirmation:
With repeat pressing onto timer key choose right or left zones you want to set
as the LED light showing. The display shows "00". With the keys "0-9" set the time in 1-minute steps
(max. 99 min.) After 3 seconds no number level key be pressed, the time will start timing and the
display will indicate the countdown time until to "00".if two zones has been set time, the display will
indicate alternate
Timer cancellation
By pressing onto timer key choose the zone you want to cancel the timer. Then press number level
key"0" two times and the timer function will be cancelled.

Safety systems

In order to protect the electronics from overheating if the control unit detects excessive heat it will
switch off the hotplate closest to the sensors and the letter H will appear on the display. This hotplate
can be activated when the temperature of the electronic unit returns to normal.
Each hotplate is equipped with an interior temperature limiter that switches off the hotplate if the
radiant surface is heated excessively.
If any cracks appear in the radiant surface, immediately disconnect it from the mains. Do not use any
part of the cooktop until a new radiant surface has been fitted.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis