Function - On / Off - Kapego 843003 Bedienungsanleutung

Manual
Article No.: 843003

6.1. Function - On / Off

The ART 9RGBW can be connected to a DC voltage of 12V to 24V. Then the display of the power
button lights up, the unit turns on and assumes the same settings as the last time.
In normal mode, touch and hold the POWER button 2s to put the ART-9RGBW into standby mode.
At this time the output is switched off. Tap the power button and hold for 2 seconds to turn the unit
on.
6.1.1. Setting Shortcut for Power ON/OFF
● Hold down the „P" and „Power" buttons simultaneously for about 10 seconds until all buttons
flash once briefly.
● Press the „Power" button once and the ART-9RGBW go into standby mode. Press any key to
start the ART 9RGBW.
● To delete the Speed Dial on / off, press and hold the „P" and „Power" buttons simultaneously
for about 10 seconds until all buttons will blink once.
6.1.2. Setting Fadetime for Power ON/OFF
● Hold the button „Power" button for 5 seconds until all LEDs blink once. Release the Power
button and the button flashes repeatedly.
● Choose one of these buttons 1-9, P, C, B or S according to set the fade time as in the table
Key 1
Fade-Time 1s
● All indicator lights will flash once to confirm the setting.
● The existing mode ends and automatically switches to normal operation.
2 3 4 5
2s 3s 4s 5s
6 7 8
6s 7s 8s
6
9 P/C/B/S
9s 0s (no Fade-Time)