Blade Rick and Morty RM1001 Bedienungsanleitung Seite 5

How to connect to Steam Deck:
1. Press and hold the "Y + HOME" buttons for 3 seconds to activate the
pairing mode.
2. LED 1 and 4 will flash rapidly.
3. Open Bluetooth settings in Steam Deck and add deviceLook for the "Pro
Controller Rick And Morty" device to successfully pair the controller.
4. When pairing is complete, status LED number 1 and 4 will light up.
Setting the three lighting modes:
1. Press the "Light" button to switch between the 3 lighting modes - Brea-
thing / Fixed / Off.
2. Breathing mode - Color cycle: Press the "Light" button once.
3. Fixed mode: Press the "Light" button once again on the color of the
color cycle you wish to set.
4. Off mode: Press a third time to turn off the LED lights.
Vibration setting (Nintendo Switch compatible only):
Press and hold "L1+L2+R1+R1+R2" buttons for one second to adjust the
vibration intensity. The setting cycle is 100%>70%>30%>30%>0.
The LEDs indicate what percentage you are at:
1. LED1 100%.
2. LED2 70%
3. LED3 30%
4. LED4 0%
Setting TURBO mode (Configurable buttons: A/B/X/Y/L1/L2/R1/R2)
1. Press the "TURBO + button to be set" button to enter the manual mode
(the action button is pressed repeatedly while holding it down).
2. Press the "TURBO + button you want to configure" button a second
time to make the action button actuate repeatedly automatically, without
having to press the button physically.
3. Press the "TURBO + button to be configured" button a third time to
deactivate the "TURBO" option for that button.
4. Press and hold the "TURBO" button for 5 seconds to disable all buttons
configured with "TURBO". The LED indicators will flash 3 times and the
controller will vibrate to indicate successful deactivation.
"TURBO" mode frequency levels:
1. Press "TURBO+Up Arrow": Fast frequency, approximately 20 times per
second.
2. Press "TURBO+Down Arrow": Slow frequency, approximately 5 times
per second.
3. Press "TURBO": Medium frequency, approximately 10 times per
second.
How to calibrate the gyroscope:
1. With the controller off, position it horizontally on a flat surface.
2. Press and hold the "HOME + Menu/-" buttons and the 4 status LEDs
(1,2,3 and 4) will light up alternately.
3. Press the "Menu/+" button to confirm the calibration. The LED indicators
will turn off in 3 seconds.
Charging status indicator:
• Charging not connected to a console: The 4 status LEDs will blink
during charging time and turn off once 100% charged.
• Charging connected to a console: The LED indicator corresponding to
the channel to which it is connected will blink during charging and will
stay on steady when charging is complete (100%).
Sleep mode or Auto-sleep:
The controller will automatically turn off after being idle for 5 minutes or if the
console enters sleep mode.
Technical parameters:
• Standby current: <20uA.
• Working current: About 25mA
• Working voltage: 3.0V
• Input voltage: DC 4.7~5.5V
• Charging current: about 450mA