LOXONE Smoke Detector Air Kurzanleitung

Smoke Detector Air
Article No.: 100142
Part No.: 32988
Technical Instruction No.: 54509
This smoke detector with integrated Loxone Air technology
ensures greater safety in your home!
• Optical detection principle
• Sound alarm
• Early fire detection
• Operates autonomously
• Works with Loxone Air for integration into a Loxone Smart
Home
• Includes long-life battery
• Tested according to EN 14604
TECHNICAL DATA
Detection principle
Alarm display
Operating voltage
Operating temperature
Humidity
Max. area of monitoring
Air velocity
Sensitivity
Protection
Case material/colour
Dimensions (H x D)
Weight
Please note technical specifications may change at any time!
PRODUCT DETAILS
• 1x Smoke Detector Air
• 1x Tested 9V battery
• 1x Wall plugs + screws for mounting
loxone.com
LOXONE Smoke Detector Air / 100142
Tyndall effect
Optical (Red LED and audible
beep > 85 dB (A)/3 m)
9V DC
-10°C to +60°C
max. 93 % RH +/- 2 % RH
60 m to 6 m high
2
Max. 20 m/s
Typ. 0.15 dB/m
IP40
ABS/white
56 mm including base x
110mm
Approx. 0.18 kg
ASSEMBLY
1. Choosing location:
•
Mount on the ceiling
• Mount in the centre of the room for optimum detection
ability
•
Minimum distance of 50 cm from walls, lamps and mains
cables
• The following places are not appropriate for mounting:
- Rooms that typically have high humidity (e.g. kitchen,
bathroom, toilets)
- Near fireplaces or woodburners
- In rooms that have temperatures lower than -10 °C or
higher than +60 °C.
- Near ventilation shafts
- In narrow corners
2. Drill holes with a 6 mm drill bit with a hole spacing of 67
mm for the 2 mounting screws (use the lower edge of the
detector as a drilling template).
3. Insert the wall plugs into the holes.
4. Secure the base using the supplied screws.
5. Learn in the Smoke Detector Air:
5.1 Insert the battery (with the new firmware the Smoke
Detector Air immediately goes into learn mode).
5.1.1 Or press the Air learn button for 5 seconds ->
detector will now be in learn mode.
5.2 Start Loxone Config and connect to the Miniserver.
Select the Air Base in the Periphery window and then
enable the Air monitor. Start search.
5.3 Select the Smoke Detector Air in the search.
5.4 Enter a name.
5.5 Click create device.
5.6 Save the program in the Miniserver.
6. Put the detector on the base and lock by rotating
clockwise.
7. Carry out a functionality test.