oneConcept RV1 Handbuch Seite 12

Step 2: Mount the bracket to your car instead of the old one.
Step 3: Lead the camera cable into the trunk in a suitable manner and connect it to the trans-
(Video Out -> Video In DC 12V -> DC 12V Out).
mitter device //
Step 4: Connect the black cable of the transmitter with the ground (negative pole of the ve-
hicle's battery or any grounded part of the car chassis).
Step 5: Connect the red cable to the positive pole of the vehicle electronics. You can use any
12V current that is fed by the ignition or the lights (any source that is not continiously fed by
the car battery, but controlled by ignition or lights).
Step 6: Mount your license plate into the bracket by first pushing it into the upper gap, and
then, while pushing the plate against the bracket, sliding it into the lower slot.
Step 7: Adjust the camera angle and then secure the camera by fasten the two small screws
beside it.
Put the square locks (see p. 11) into the intakes on the top of the bracket to secure the plate.
12