DS Produkte CARS RIVALS TS-28763 Bedienungsanleitung Seite 4

EN
ITEMS SUPPLIED
2 x car with integrated rechargeable
battery
2 x doll
Check the items supplied for completeness and the components for transport
damage. If you find any damage, do not use the product but contact our customer
service department.
Remove any films, stickers or transport protection from the product. Never
remove the rating plate and any possible warnings!
L
To charge the cars from a plug socket, a USB power adapter (see the
"Technical data" chapter) is required. This is not supplied with the product.
In addition, two batteries (1.5 V; AAA) are required for each remote
control. These are not supplied with the product.
PRODUCT OVERVIEW
5
4
6
10
REMOTE CONTROL: INSERT BATTERIES
1. Undo the screw on the battery compartment (4) with a screwdriver (not
supplied with the product) and remove the battery compartment cover.
2. Check whether the contacts are clean, and clean them if necessary.
3. Insert two batteries (1.5 V AAA). Pay attention to the correct polarity (+ / –).
4. Place the battery compartment cover back on and fix it in place with the screw.
Replace the batteries when the power starts to wane.
CAR: CHARGE BATTERY
Please Note!
■ Do not charge on a computer because the high charging current could
damage the computer.
■ To charge from to a plug socket, a USB mains adapter (5 V DC, ≤ 2 A; not
supplied with the product) is required.
■ Only connect the mains adapter to a plug socket that matches the technical
data of the battery. The plug socket must be readily accessible so that the
connection to the mains can quickly be isolated.
■ Charge up the battery fully before you first use the product in order to
achieve the maximum charging capacity.
Article number: 15241
2 x remote control
2 x charger cable (USB-A to USB-C)
1 x operating instructions
Remote control
1
1 Transmitter
2
2 OFF | ON – Switch
with indicator light
3
3 Joystick: turn left / right
4 Battery compartment (back)
5 Joystick: drive forward / reverse
Car (top)
6 Spring pins for ejecting the doll
7 Back light
8 Slot for doll
9 Front light
7
10 Buttons for ejecting the doll
8
9
Car (bottom)
11 Indicator light
11
red – car is charging
12
off – car is charged
12 CHARGE – Charging socket
13
13 ON | OFF – Switch
14
14 R | L – Direction correction
control
1. Slide the switch (13) on the car to the OFF position.
2. Connect a charging cable to the charging socket (12) on the car and to a
power source with a USB interface (preferably via a USB mains adapter to the
plug socket).
3. Connect the mains adapter to a plug socket. The battery starts charging
and the indicator light (11) lights up red. As soon as the battery is fully
charged up, the indicator light goes out.
4. Disconnect the charger cable from the power source and then from the car.
PAIR REMOTE CONTROL WITH CAR
1. Slide the switch (2) on the remote control to the ON position.
The indicator light on the switch flashes.
2. Within approx. 60 seconds: Slide the switch (13) on the car to the ON position.
As soon as the remote control is paired with the car, the indicator light on
the remote control goes out.
3. Repeat the steps 1 and 2 with the other car and the other remote control.
USE
• Switch on: Slide switch (2, 13) to the ON position.
• Place a doll: Press the two spring pins (6) down. They must engage. Then
insert the doll into the slot (8) of the car, until it clicks into place.
• Driving: Press the joystick (5) at the front or back.
• Correct the driving direction: If the car does not drive in a straight line
without steering, turn the direction correction control (14) to correct the
driving direction.
• Steering: Press the joystick (3) left or right.
• Eject the doll: Touch one of the buttons (10) (e.g. with the other car).
The doll is ejected upwards and a sound is heard.
• Switch off: Slide the switch (3, 10) to the OFF position.
TECHNICAL DATA
Article number: 15241
Model number: TS-28763
Power supply: – Car: 2 x 3.7 V
– Remote control: 3 V
Charging time (car): approx. 3 – 4 hours
Operating time (car): approx. 15 – 18 minutes (with fully charged battery)
Range (car – remote control): max. 20 meters
Signal transmission: 2.4 GHz radio (2405 – 2475 MHz)
Mains adapter required: 5 V DC, ≤ 2 A
ID Operating instructions: Z 15241 M DS V1 0724 as
NOTICE ON THE DECLARATION OF CONFORMITY
DS Produkte GmbH hereby declares that the radio equipment with model number
TS-28763 (Article number 15241) conforms to Directive 2014/53/EU.
The complete text of the EU declaration of conformity is available at the following
internet address: https://www.ds-group.de/kontakt
DS Produkte GmbH, Stormarnring 14, 22145 Stapelfeld, Germany
CUSTOMER SERVICE
Am Heisterbusch 1, 19258 Gallin, Germany
✆
+49 38851 314650 *) • kundenservice@dspro.de
*) Calls to German landlines are subject to your provider's charges.
Operating Instructions
(Li-Ion battery 500 mAh)
(2 x battery type AAA)
All rights reserved.