Before Assembly - Palram Utility Shed Shelf Kit Handbuch

IMPORTANT
Please read
these instructions carefully before you start to assemble this
shelf.
Please
carry out the steps
in
the order
set
out
in
these instructions.
Keep these instructions
in
a
safe
place for future reference.
Tools &
Equipment
44
supplied)
Care
and Safety Advice
Some parts may have sharp edges. Please be careful when handling components.
Dispose of
all
plastic
bags safely
-
keep them out of
reach
of small children.
Keep
children away from the assembly
area.
Before Assembly
Sort the parts and check according to the contents parts list.
Cutting the panels and profiles
in
only needed when installing the
shelves
from
the corner or installing
3
or more shelves side by side.
When installing the shelves side by side, some parts may
be
surplus.
Steps
Step
1:
Installation
varies
between
sheds, if you haven't inserted the screws
for
shelves
installation
in
advance: disassemble the part
in
accordance with the drawing
in
step
1,
insert the screws, re-assemble and re-tighten.
(If you plan to install the shelves from the corner, for the Yukon Shed only, check step
12
for inserting the screws to the corner profile).
Step
3: Please
note you should bend only profile #8917.
Do
not bend profile #8916!
Step
8: This step
is
for installing
a
single shelf and
is
compatible with
all Palram sheds,
the
rear
profile will
reach
the brackets' end or
surpass it,
depending
on
the
shed.
Step 9: This step
is
for installing
2
shelves side by side, the profiles should
be
attached
in
the middle of the central bracket, the
ends
will
pertrude.
Step 12: From this step onwards, there
are
instructions to install the shelf from the corner, possible only
with the
Yukon sheds.
Step 15 + 16: Make sure you plan and mark
prior to cutting.
Step
20:
Optional
-
it
is
possible
to install the
shelves along the entire wall, you may have
to cut the
panel and profiles
in
half.