Enrico M-Line 3 IN 1 GRILL Gebrauchsanleitung Seite 10

3. Pull the pizza pan out of the device, carefully place a pizza on it and then slide the pan back into the
device. After a few minutes, check whether the pizza is cooked and whether it is too brown and, if the
latter is the case, reduce the temperature.
4. If the pizza is cooked, turn the On/Off switch to the OFF position.
5. Fully remove the pizza pan from the device, slide the pizza onto a plate and place the pan on a heat-
resistant surface to cool down.
6. Clean the pizza pan (see the "Cleaning and Storage" chapter).
Skewers
1. Turn the On/Off switch to the III position.
2. Turn the temperature controller (3) to the highest setting (approx. 200°C) and allow the device to heat
up for a short time.
3. Pull out the skewer, insert the food on the skewer, then put the skewer into the device. After a few
minutes, check whether the food is cooked or not.
4. If the skewers are ready, turn the On/Off switch to the OFF position.
5. Fully remove the skewers from the device, and place them on a heat-resistant surface to cool down.
6. Clean the skewer.
Cleaning and Storage
CAUTION!

Danger of burns from hot device parts! Allow the device and the accessories to cool down before
any cleaning.

Danger to life from electric shock! Remove the mains plug from the plug socket before doing any
cleaning. Never immerse the device, the mains cable or plug in water. Never put the device and its
component parts in the dishwasher.

Do not spray cleaning agents directly onto the device. Do not use any glass cleaners.

Do not use corrosive or abrasive cleaning agents, rough sponges or knives to clean the device. These
can damage the surface.
Remove all food residues from the grill plate or pizza pan after each use. Then rinse the plate/ pan with
detergent and warm water.

If necessary, clean the device housing and the heating elements with a damp cloth/sponge and then
wipe down the surfaces so that they are dry.

If the crumb collection tray is full, pull it out of the back of the device. Remove any food residues and
clean it with a detergent and warm water.

Allow all parts to dry completely before you insert them back into the device.

Store the device out of the reach of children and animals. Keep it in a dry, frost-free place which is
protected from direct sunlight.