Replacement Instructions - Jecod Rf-B Serie Bedienungsanleitung

4.2.

Replacement Instructions

1. Accessories included: 3 x 1.5 AA batteries, sucker, bracket.
2. To replace the battery, you need to open the battery compartment.
3. To add feed, open the top cover of the feed silo and pour in the feed.
5. Operation Settings
5.1. Feeding Portion Setting
Press the " " key to set the portion size and turn on timing mode. The default is 1 portion, press it to add 1
portion. 3 portions are maximum. The corresponding indicator always lights up when the setting is completed.
Press fourth to close the timing, namely 1-2-3, turn off the 1-2-3 cycle.
5.2. Feeding Time Setting
With the timer mode on, press the "
feeding every 8 hours, according to the set amount.
Press again, then 12 h indicator lights up. The feeder starts feeding every 12 hours, according to the set
amount.
Press again, then 24 h indicator lights up. The feeder starts feeding every 24 hours, according to the set
amount.
Press again to turn off the feeder. Cycle from 8 h to 12 h, then to 24 h, and finally to shutdown in sequence.
Note: Each feeding time for 1 portion is 2 seconds. Indicators with "1", "2", "3" display relevant
portions. Auto save settings within 5 seconds.
5.3. Manual Feeding
Press "Manual" for manual feeding and start feeding 1 time. The indicator light is always on when feeding. The
collection container can be replaced by pressing and holding the "Manual" button for more than 2 seconds.
6. Maintenance
1. This product is suitable for indoor use only. Do not soak in water.
2. Please clean the canister before changing food to avoid food sticking to the feed silo due to moisture.
3. Clean the canister regularly and keep it dry to prevent the feed from agglomerating (at least once a month.
4. Do not flush the canister with water.
5. Do not touch buttons with wet hands.
7. Troubleshooting
Problem
No display on control panel.
Feeding light is flashing.
6
" key to set timing, then 8 h indicator blinks every 10s. The feeder starts
Reason
Low battery.
Loose internal connecting cable.
The switch is off.
Feed agglomeration
Solution
Replace battery.
Open the battery
reattach.
Turn the switch on.
Smash the feed.
compartment to