EN
EN - USER MANUAL
Multi-Function Rechargeable Inspection Lamp
DBPF-0124
THE SWITCHES:
• Click the switch to cycle through modes:
XTE high
XTE low
White SMD
Warm SMD
Red SMD
Red SMD strobe
• Long press the switch to turn the lamp off in any mode.
• Click the switch 8 seconds after releasing it to turn the light
off in any mode
PRODUCT OVERVIEW:
• The light has a ruler function with a measuring range of 0–15
cm.
• Magnet and hook: Equipped with a magnetic base for
easy attachment to metal surfaces and a hook for hanging
anywhere.
• Digital power display: Easily monitor battery power usage.
SAFETY WARNINGS:
• The device uses a rechargeable lithium battery. Charge as
required. Improper charging may cause battery damage,
short circuits, fire, or explosion.
• Fully charge before long-term storage to prevent battery
over-discharge and self-discharge damage.
• Do not shine directly into a person's eyes. Bright light may
cause temporary blurred vision, especially in children.
• Always close the charging cover when not charging.
• This device is not a toy. Keep out of reach of children.
SPECIFICATIONS:
• Material: ABS
• Lamp: XTE + SMD (8 White + 7 Warm + 2 Red)
• Battery: 1 × Polymer lithium-ion battery, 600 mAh (included)
• Size: L 187 × W 24 × H 17 mm
• Weight: 73 g (with battery)
• Brightness: 250 lumens
• Charging time: 2 hours
• Working time: 3–6 hours
HOW TO REMOVE THE BATTERY:
1. Use a screwdriver to remove the screws.
2. Gently lift the printed circuit board.
3. Carefully pry up the battery with a flat tool (e.g., slot scre-
wdriver) to separate it from the double-sided tape. Pry slow-
ly to avoid damage.
4. Grip the battery interface and slowly pull the battery out.
DECLARATION OF CONFORMITY
DECLARATION OF CONFORMITY AVAILABLE AT THE
REGISTERED OFFICE OF AMIO SP z o.o. ul. Handlowa 3,
41 - 807 Zabrze
WASTE MANAGEMENT AND RECYCLING
This symbol indicates that this product should not be
disposed of with unsorted municipal waste. Electronic
equipment should not be disposed of with household waste.
According to the European Directive 2002/96/EC on waste
electrical and electronic equipment and its incorporation into
national law, waste electrical and electronic equipment must
be collected separately and recycled. You can also take your
used equipment to an electronic waste collection point, which
disposes of the equipment in accordance with the National
Recycling and Waste Act. It also helps to avoid potential
damage to the environment and human health and helps to
conserve natural resources.
INSTRUCTIONS FOR OPERATION AND SAFETY
OF BATTERIES IN AMIO PRODUCTS
PRECAUTIONS
• Do not throw into fire — batteries may explode or leak.
• Do not disassemble or crush — this can cause leakage of
chemicals that are harmful to health.
• Do not recharge disposable batteries — this can lead to
overheating, leakage or explosion.
• Avoid short-circuiting — do not connect the battery
terminals with a conductor, such as a coin or key. This can
cause overheating and damage to the battery.
• Keep away from children and pets — swallowing batteries
can be dangerous and requires immediate medical
attention.
USE
• Use only as intended — make sure the battery
is compatible with the device.
• Always insert batteries correctly — pay attention to the
poles (+ and -).
• Don't mix different types of batteries — don't use new
and used batteries or different brands together, as this can
P/N: 04669, 04670
1