AMiO 01020 Gebrauchsanweisung

EN
WIRING DIAGRAM / SCHEMAT POŁĄCZEŃ / DIAGRAM ZAPOJENIA
REVERSE OR IGN
EN - OPERATING INSTRUCTIONS
TFT display
TECHNICAL PARAMETERS
• input voltage DC 12V
• operating frequency 40 kHz
• working temperature -30°C - +70°C
• dimensions 116x68mm
• resolution 480p
• diagonal screen size 4.3"
• operation systems PAL / NTSC
USE OF THE DEVICE
Step 1: Switching on the display
The display switches on when the ignition is turned on
or when reversing, depending on the connection of the
camera and the display
Step 2: Viewing the image
The image from the reversing camera should appear on
the display screen.
Monitor the image, which shows the view from the rear
of the vehicle. Make sure that the image is clear and
REVERSE OR IGN
+
+
-
-
adequately illuminated.
Pay particular attention to obstacles, other vehicles,
pedestrians or cyclists that may be in the field of view of
the reversing camera.
Step 3: Additional settings
The display allows you to adjust settings such as
Brightness, sharpness, colour saturation and the format
of the displayed image
Step 4: Using the reversing display
The reversing display is active when you are reversing.
Make sure you are in reverse mode, most commonly by
engaging reverse gear.
Using the image on the display, keep track of your vehicle's
surroundings and perform reversing manoeuvres carefully
and safely.
Remember that the reversing display is only one of the
aids. You still need to rely on your mirrors, turn your head
and use other methods of observing your surroundings to
get the full picture.
Step 5: Maintenance and safety
Regularly check the condition of your reversing display to
ensure it is clean and fully functional.
If you notice any damage, such as screen cracks or display
problems, consult a professional and take corrective
action immediately.
Remember that the reversing display is one of your
TFT display
AV1
AV2
1