Ruris RMX1240 Handbuch Seite 12

EN
5. To remove the battery from the charger, slide the battery back.
Installing the battery
1) Before inserting or removing the battery, you must release the
switch and make sure the car stops
2) To insert the battery, make sure the ribs are aligned with the
grooves on both sides, then insert the battery into the slot.
Please make sure it is fully inserted until it makes a "locking"
sound. If not locked, the battery may fall out accidentally.
3) To remove the battery, press the release button, then remove
the battery in the direction of the arrow.
Installing and removing the accessory
Remove the battery from the tool before making any changes.
Open the chuck by rotating it in the direction of rotation until the
tool can be inserted. Insert accessory. Firmly tighten the chuck
by rotating it in the tightening direction, this will automatically lock
Direction of rotation switch .
Always check the direction of rotation before operation. Only use the reverse switch after
the tool has come to a complete stop. Push the direction switch from right to left or vice
versa depending on the desired direction of rotation Changing the direction of rotation
before the tool is stopped can damage the tool. When not using the drill and driver, always
set the reverse switch lever to the neutral position. Before use, check the set direction of
rotation.
The images are informative, the supplier reserves the right to make structural and functional changes to the
machine presented in this manual.
Maintenance of tools
Always keep guards, vents and engine housing clean, free of dust and dirt. We recommend that you clean
your device every time you use it. Clean the equipment regularly with a damp cloth. Do not use cleaning
agents or solutions as they may damage the plastic parts of the equipment. Make sure that no water gets
into the device.
Clean the ventilation slots regularly. The drilling and screwing machine does not require special maintenance.
Never use water or chemical detergents to clean power tools. Wipe with a cloth.
Always store the tool in a dry place.
Do not dispose of electrical equipment, industrial electronics and components in household
waste! Information on WEEE. Considering the provisions of GEO 195/2005 - regarding
environmental protection and GEO 5/2015. Consumers will consider the following
indications for handing over electrical waste, specified below:
- Consumers have the obligation not to dispose of waste electrical and electronic equipment
(WEEE) as unsorted municipal waste and to collect this WEEE separately.
- The collection of these named wastes (WEEE) will be carried out through the Public Collection Service within
each county and through collection centers organized by economic operators authorized for the collection of
WEEE. Information provided by the Environmental Fund Administration
European Union.
- Consumers can hand in WEEE free of charge at the previously specified collection points.
6
6. MAINTENANCE
Buton de
eliberare
acumulator
www.afm.ro or the journal of the
Acumulator