Beck INDUSTRY 115 Inbetriebnahmeanleitung

com.tom INDUSTRY 115 – Start-up Guide
The CTI 115 devices communicates with the
com.tom PORTAL via Ethernet and the existing
network infrastructure. The communication
mechanism has a low data volume and can be
integrated easily in the existing network infra-
structure.
Device may only be put into service and operated by qualified
personnel.
The device is designed for an installation on a 35 mm DIN Rail in
dry rooms.
The power supply must be a grounded circuit (PELV).
The power supply must be a limited power source according to
EN60950-1 cap. 2.5 or the device must be provided with an anti-
surge fuse of 2 A
Pin Assignment
Power Supply
FE Functional earth
GND Ground
VCC 24 VDC
Serial Interface
RS485
Pin A A (- / Y)
Pin B B (+ / Z)
Ethernet Interface
ETH 0
Green LED Link indication
Yellow LED Activity indication
ETH 1
Green LED Link indication
Yellow LED Activity indication
LEDs
P Device is powered
A PLC status
B Portal status
Other Interfaces
micro SD card interface micro SD memory card
Getting Started
Wire the com.tom device according to the technical data. Get
the appropriate
Getting
http://www.com-tom.de/start and follow the steps described
there to put your device into operation.
Part Numbers
00571218 (WEB-PLC) CTI 115.W
00571222 (WEB-PLC) CTI 115.W Starter Kit
00571310 (CODESYS) CTI 115.C
00571260 (CODESYS) CTI 115.C Starter Kit
General Data
Size (W x L x H) 36,5 x 61,5 x 99 mm
Operating temperature 0 to 55 °C
Electrical shock Class III
Protection rating IP20
EMC emission IEC 61000-6-3
EMC immunity IEC 61000-6-2
Compliance CE, RoHS
Electrical Data
Supply voltage
24 VDC (15 %)
Active current < 50 mA (without I/Os)
Scope of supply
1 Piece CTI 115
1 Piece microSD card
1 Piece Connector 3-pin
1 Piece Connector 2-pin
1 Piece Label MAC-ID
1 Piece Start-up Guide
documentation at
Started
Copyright © 2018 Beck IPC GmbH
http://www.com-tom.de