Steinemann ULR CONDTROL Benutzerhandbuch

UNIVERSAL LINE RECEIVER
ULR CONDTROL
EN
Congratulations on your purchase of universal line receiver ULR CONDTROL.
Safety instructions can be found in the end of this user manual and should be carefully
read before you use the device for the first time.
SAFETY REGULATIONS
The user manual should be read carefully before you use the device for the first time.
Unintended use of the device can be dangerous for human's health and cause serious
injury. Keep this user manual. If the device is given to somebody for temporary use, be
sure to enclose user manual to it.
- Do not misuse the device.
- Store the product beyond reach of children and unauthorized people.
- It is prohibited to disassemble or repair the product yourself. Entrust product repair to
qualified personnel and use original spare parts only.
- Do not use the product in explosive environment, close to flammable materials.
- Avoid heating the battery to avoid the risk of explosion and electrolyte leakage. In case
of liquid contact with skin, wash it immediately with soap and water. In case of contact
with eyes, flush with clean water during 10 minutes and consult the doctor.
INTENDED USE
ULR CONDTROL is a multi-frequency line receiver designed to increase the working
range of laser levels with red and green beam. 2 working surfaces make operation more
convenient both indoors and outdoors. With this receiver the user can take readings on
the target scale, which is on the back side of the receiver or follow the LEDs on the front
side of the housing. Magnets inbuilt in the housing make it possible to fix the receiver on
a ceiling profile or a vertical structure for easy and quick level adjustment.
1
3
2
2
1
7
6
2
8
1 – Bubble level 5 – Target
2 – LED indicators 6 – Power on/off
3 – Photocell 7 – Audio signal on/off
4 – Magnets 8 – Battery cover
DELIVERY PACKAGE
Universal line receiver – 1 pc.
Mount of fixing on a leveling staff – 1 pc.
Batteries (1.5V AAA LR03) – 2 pcs.
User manual – 1 pc.
TECHNICAL SPECIFICATIONS
Compatibility with laser levels
Operating frequency
User manual
Accuracy
Detecting range
Length of photocell
Receiver working angle
Bubble accuracy
Power supply
Battery life
IP rate
Operating temperature
Storage temperature
Dimensions
Weight
INSTALL/REPLACE BATTERIES
Use a screwdriver to loosen the screw of the battery cover and remove it.
Install the batteries, observing the polarity.
Replace the battery cover and use a screwdriver to tighten the screw.
Use alkaline batteries only. Both batteries must be of the same brand, with the same
charge level.
OPERATION
4
In bright light, when it is hard to see the laser line, it is reasonable to use universal line
receiver.
Press to switch on the receiver. Press
Bring the receiver to the intended place of location of the laser line. As soon as the
laser line hits the photocell, the receiver emits audio signal, one of the LEDs lights up,
indicating the direction of movement of the receiver to catch the laser line.
Move the receiver until you hear a continuous audio signal and the central LED lights up.
Check the alignment of the receiver housing by the bubble level and make a mark on the
surface or remember the result of the height if the receiver is fixed on a leveling staff.
CARE AND MAINTETANCE
Attention! Laser receiver is a precise device and requires careful handling.
Maintenance of the following recommendations will extend the life of the device:
5
- Store the product, spare parts and its accessories beyond reach of children and
unauthorized people.
- Keep the product clean and protected from any bumps, dust and dampness; do not
allow moisture, dust or other dirt get inside of the product.
- If moisture goes into the product, remove the battery and take it to the service center.
- Do not keep or use the device for a long time at high humidity conditions.
- To clean the product use a soft wet cloth. Do not use harsh chemicals, cleaning solvents
or detergents.
Mishandling of the following rules can cause electrolyte leakage from the batteries
or other damages:
- Remove the battery from the product if you do not use it for a long time.
- Do not leave discharged battery in the laser level.
UTILIZATION
Expired tools, accessories and package should be passed for waste recycle. Please send
Wavelength within 500 – 700 nm the product to the following address for proper recycle:
5...10 KHz
CONDTROL GmbH
Wasserburger Strasse 9
+1 mm/10 m
84427 Sankt Wolfgang
0,1 m...100 m Germany
40 mm
Do not throw the product in municipal waste!
According to European directive 2002/96/ЕC expired measuring tools and their
>±45°
components must be collected separately and submitted to environmentally friendly
recycle of wastes.
30'/2 mm
1.5V AAA LR03 alkaline
WARRANTY
All CONDTROL GmbH products go through post-production control and are governed
about 30 hours
by the following warranty terms. The buyer's right to claim about defects and general
provisions of the current legislation do not expire.
IP54
1) CONDTROL GmbH agrees to eliminate all defects in the product, discovered while
-10°С...+50°С
warranty period, that represent the defect in material or workmanship in full volume
and at its own expense.
-10°С...+50°С
2) The warranty period is 24 months and starts from the date of purchase by end
customer (see the original supporting document).
100×62×18 mm
3) The warranty doesn't cover defects resulting from wear and tear or improper use,
120 g (with batteries)
malfunction of the product caused by failure to observe the instructions of this user
manual, untimely maintenance and service and insufficient care, the use of non-original
accessories and spare parts. Modifications in design of the product relieve the seller
from responsibility for warranty works. The warranty does not cover cosmetic damage,
that doesn't hinder normal operation of the product.
4) CONDTROL GmbH reserves the right to decide on replacement or repair of the device.
5) Other claims not mentioned above, are not covered by the warranty.
6) After holding warranty works by CONDTROL GmbH warranty period is not renewed
or extended.
7) CONDTROL GmbH is not liable for loss of profit or inconvenience associated with a
defect of the device, rental cost of alternative equipment for the period of repair.
This warranty applies to German law except provision of the United Nations Convention
on contracts for the international sale of goods (CISG).
to switch on/off audio signal.
In warranty case please return the product to retail seller or send it with description of
defect to the following address:
CONDTROL GmbH
Wasserburger Strasse 9
84427 Sankt Wolfgang
Germany
Subject to change