Technical Data; Installation Notes - Dtm System Pomena Benutzerhandbuch

1. USAGE
POMENA series signal lamps are designed for the automation industry, wherever there is a need
for a warning light signaling the operation of automatic devices, mainly gates and barriers. The
lamp is available in version POMENA24, POMENA24B powered by 24V AC/DC, and POMENA230,
POMENA230B powered by 230V AC. The lamps have a built-in dual-band antenna to improve the
radio range. If it is necessary to increase the radio range, use an additional external antenna
mounted on a lamp-compatible stand, available as an option from the manufacturer.

2. TECHNICAL DATA

power supply
power
operating temperature
technology
vitality
usage
operating mode
housing dimensions
montage
IP
waga
antenna

3. INSTALLATION NOTES

Flashing light serves its purpose only if it is installed in a place where it is clearly visible to people in
the automation working area.
In POMENA B series lamps with a transparent shade, it is possible to obtain white light by
removing the internal orange shade from the electronics board (Fig. 5. page 9).
4.LAMP MOUNTING
The lamp is mounted as standard on a horizontal plane (Fig. 6, p.9). Using the supplied bracket,
lamp can be mounted on a vertical plane (Fig. 7, p.10).
POMENA230, POMENA230B - 230V AC,
POMENA24, POMENA24B - 24V AC/DC
max 5W
-20°C to +55°C
LED
50 000h
signal light
constant or impulse 0,5s
110x118x mm (without the angle bracket)
directly or with the angle bracket
IP 44
180g (with the bracket 250g)
built-in dual band: 433MHz and 868MHz
230VAC dangerous voltage present in POMENA 230 and POMENA 230B
lamp. Mechanical and electrical installation should be performed by
qualified personnel with adequate knowledge and tools in accordance
with the rules in force at the installation site. Before installing make sure
the supply voltage at the controller output is correct for your lamp
model. All the work of connecting the lamp to the installation should be
performed with the controller power supply disconnected.
94
7
EN