Guidecraft POWERCLIX Bedienungsanleitung Seite 12

This device complies with Part 15 of the FCCRules.
Operation is subject to the following two conditions:
{1)This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
Note: This product has been tested and found to
ply With the limits for a ClassB digital device,
pursuant to Part 15 of the FCCRules.These limits are
designed to provide reasonable protection against
harmful intefference in a residential
This product generates, uses. and can radiate radio
frequency energy and, if not installed and used in
accordance With the instructions, may cause harmful
interference to radio communications
there is no guarantee that interference will not occur
in a particular installation- "f this product does cause
harmful interference to radio or telewsaon reception,
which can be determined by tu ming the equipment
off and on, the user is encouraged to try to cotrect the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna,
—Increase the separation between the equipment
receiver.
—Connect the equipment into an outlet on a circuit
different from that to which
—Consult the dealer or an experienced
techniCian for help.
Pleasetake attention that changes or modification
not exprssty approved by the party resl»nsible for
com pliance could void the users authority to operate
the equipment.
This dewce compl ies with Industry Canada licence•
installation,
However,
and
the receiver is connected
radiO/TV
exempt RSSstandard(s), Operation is subject to the
following two conditions:
{1) this device may not cause interference, and
this device must accept any interference. includi ng
interfetence that may cause undesired operation of the
Le present appareil est conforme aux CNRcflndustrie
Canada applicables appareils radjoexempts
licence. lÄplOitatiOn est autoriSée aug deux conditions
suivantes
{1) rappareilnedoit pas produire de brouillage. et
(2) rutilisateur de rappareil doit accepter tout
brouillage radi0électrique subi, meme Si le brouillage
est susceptible den compromettre
Under Industry Canada regulations this radio
transmitter may only operate using an antenna of a
type and maxim urn lesser) gain approved for the
transmitter by Industry Canada. To reduce potential
radio interference to other users,the antenna type
and its gain should be so chosen that the equivalent
isotropically radiated poweT
that necessary for successful communication.
Conformément la reglementation dlndustrie Canada,
le present émetteur radio peut
fonctionneT avec une antenne d'un type et d'un gain
maximal Iou inféfieur) apptouvé
Industrie Canada. Dans [e but de réduite les risques
de btouillage radioélectnqoe
utilisateurs, il faut choi5ir le type d'antenne et son
gain de sorte que la puissance isotrope rayonnée
equivalente ne dépasse pas lintensité
necessaire å létabdissement
satisfaisante.
de
le fonctionnement.
iSnot more than
pout r pat
ntention des autres
diu ne communication