Pyle PLMOTJC11 Bedienungsanleitung

1. USE
Screw design, adjusting the height by rotating the screw manually,
it is an ideal second lifting tool for tire changing and maintenace on
your motorcycle.
2. OPERATION
1. Rotate the screw by ratchet wrench to adjust the height of the
flatform.
2. Adjust the platform to the appropriate height and place the lift to
the bottom of the motorcycle. Make sure that the center of the load
align with the pivot, and keep the load stable and safe.
3. When all of the above is done, lift the motorcycle to the appropriate
height.
4. Tighten the motorcycle with other tools to keep it stable.
5. After repairing, rotate the ratchet wrench slowly and gently to lower
the platform until it departs from pivot, and then take the lift away.
3. WARNING AND MAINTENACE
1.The lift must be used on a solid and level surface, not allowing
gradient and uneven surface.
2. Keep the load stable and prevent the load from losing balance.
3. Before using, lubricate the screw and the nuts with grease to make
the lift flexible and antifriction.
Questions
We are here to help!
Phone:
PyleUSA.com/ContactUs
or Comments?
1.718.535.1800
Visit Our Website
PIMOWCII
SCAN ME
PyleUSA com
Read this material before using this product.
Failure to do so can result inseroius injury.
SAVE THIS MANUAL.
INSTRUCTION MANUAL
PYLE
ENG
PyleUSA com