Intended Use; Battery Operation - Purelight Piko Bat Ii Benutzerhandbuch

ENGLISH

Intended use:

The PURElight PIKO BAT II was designed for use as an electronic LED lighting effect. The
device may only be used for this purpose and in accordance with the operating instructions.
Other purposes as well as operation under other operating conditions are expressly not
intended and can lead to damage to property or personal injury! No liability is assumed for
damage resulting from improper use.
It must be ensured that the device is operated exclusively by trained and competent users
who are in full possession of their mental, physical and sensory abilities. The use of other
persons is expressly only permitted at the request of a person responsible for their safety,
who instructs or supervises the use.
All connections of the device should be made before switching on. Only use high-quality
cables that are as short as possible for the connections.
Start-up:

Battery operation

Before the unit can be operated for the first time, the built-in battery must be fully charged.
Switch on the unit with the charging switch and connect the unit to a power socket using
the enclosed power cable.
Switch on the unit and wait a few seconds until it is ready for operation.
The battery life depends greatly on the operating mode and the brightness of the LEDs. The
battery life is at least 5 hours when all LEDs are lit after fully charging, up to 15 hours in
automatic and single-colour mode. When the battery is fully charged, all four LEDs on the
back of the unit light up green. The charging time is 6 to 8 hours.
The charging status is shown in the form of green and red LEDs on the back of the unit. If
all four LEDs light up green, the battery is fully charged. If only one green LED lights up,
the battery will soon be exhausted and must be recharged. The unit can still be operated
for a few minutes in this state. After that, it switches off automatically due to the protection
circuit against deep discharge.
20