Setting The Controls - In House Led Hub-Rd-Pir Benutzerhandbuch

For installation/maintenance purposes the power point must be isolated from power source by removing
the fuse or switching the circuit breaker OFF, simply isolating the electrical supply at the wall switch is
not sufficient isolation to prevent an electrical shock.
3. CONTROLS
Time-Time "ON" adjustment
The time "ON" control adjusts the time that the lights will remain on after the unit has sensed movement.
To increase time, turn the knob clockwise, to decrease, turn knob anticlockwise.
Lux-Light Level adjustment
The "Lux" control adjusts at what level of light the unit starts sensing at dusk. This control can be also
used for testing the unit during daylight hours. To test unit, or operate during the day, turn control knob
all the way clockwise position. Once unit has been tested the "Lux" control should be set to approx.,
halfway, and adjusted later if required.
Sens - Sensitivity adjustment
The Sensitivity control adjusts the level of sensitivity of the infrared Sensor. This controls the amount of
movement that is required to switch the lights on. With the knob set to minimum(anticlockwise), the unit
will only detect large amounts of movement. It is recommended that in the most situations the unit be
operated with the "Sens" control set to half.

Setting the controls

further signals.
3. Have another person moving across the center of the area to be scanned and slowly adjust the "SENS"
control toward maximum unit the unit senses the presence of the moving person, causing the sensor
lights o switch on.
Distribué par / Distribuito da / Distributed by / Vertrieben von NETELEC SRL FR - rue Philemon Laugier - 83400 Hyeres les Palmiers
1. Turn the SENS knob clockwise on the
maximum, turn the TIME knob anti-
clockwise on the minimum, turn the LUX
knob clockwise on the maximum
2. Turn the wall switch ON; the sensor
light will remain off in the beginning.
After a warm up period of 30 sec the
sensor light will start working as soon as
it receives any signal. The sensor light
will stop working
15minutes if it does not receive any
within 5SEC-