Baumer NE214 Bedienungsanleitung Seite 39

Correct code unknown If the correct code is not known: Return the counter to the factory.
Change operating parameters ➜ Input the new value with the
Line 1
Line 2
Line 3
Line 4
Line 5
Line 6
Downloaded from www.Manualslib.com
The method of accessing the programming mode is described be-
low, together with the three programming segments in the order in
which they are used.
To access programming
➜ Press the
● The system transfers from the operating to programming mode.
➜ Press the
The code applies to programming segments 1-3.
Enter code Enter with the keys
No code is entered before delivery.
Wrong code If an incorrect code is entered, then „Error" appears in the display
(as long as the key is pressed). After 15 s the system automati-
cally switches back to the operator level.
➜ Press the
Correct code ➜ When the correct code has been input, press the
● The programming segments are now called up in succession.
Programming segment 1
Information on the displays and changing individual values is also
given in section 4.
➜ Press the
● The operating parameters are now called up.
The respective LED flashes.
XP - Current counter status
P1 - Preset value 1
P2 - Preset value 2
SC - Start count value
∑ - Totalizer
- Hours counter
The dashed line represents the end of the first program field.
manuals search engine
key.
key. „CodE" is displayed.
and . Press the
key, then press
key again.
www.baumer.com
key to acknowledge.
key and enter the correct code.
key.
und keys.
NE214
39