Boss TU-70 Bedienungsanleitung

fig. I
OBOSS
GUITAR
o
3-1
3-2
fig.2
GUITAR AUTO
— Strings / Note Name table
6th strin 5th strin
GUITAR E2: 824HZ A2: 110.0Hz 03: 146.8HZ
OPEN D 02
OPEN E
OPEN G
OPEN A E2
LO-B 4th strin
BASS BO: 30.9Hz El: 412Hz
0 2000
(fig.l. fig.2$N)
1. RiäÄ-f•y3 (POWER)
10
2.34 • > (LIGHT)
3-1. • æ—F.
3-2.
3-3. wæv5-&-ti.
3-4. •
3-5. :
• F •
"b" An :
i-.—2-/5 • F'ä±3-tzY
5. • (AUTO)
6. •=.TJV • (MANUAL)
7. •
-Ta—ZY5 •
(b) (bb) /
8. (PITCH)
evy
•
(IHzäfii)
9. (INPUT)
10.7 0 • (OUTPUT)
11. (MIC)
BASS AUTOTUNER
wrpur I
3-3
} 3-4
4th strin 3rd strin 2nd strin
1st
G3: 196.0Hz B3: 246.9HZ E4: 329.6HZ
03
83
33
4
3rd strin 2nd string 1st strin
A1: 55.0Hz 02: 73.4Hz
G2: 98.0Hz C3: 130.8Hz
10
• æ—F)
(f51RXE'PJ)
(TUNING GUIDE)
"b" "#" Mkfr:
(MODE)
• E-—F •
G/
435Hz
440Hz
TU-70
12 tf "b'
8b" &
strin
: A4=435Hz—
:± 1 -ey
04
5—5—. 5--a—zs-J5• fid
04
: En;tS-006P/6F22
•
560B
Hi-C
% 110 B
21 : 149 (Z)
: S-006P/6F22
Thank you, and congratulations on your choiceof the BOSS TU-70GUETAR BASSAUTO TUNER.
Before using this unit carefully read the sections
NOTES. " These sections p rovideimportant i nformation concerning theproperoperation O ftheunit.Additionally,
in orda to feel that you havegainedagood grasp of everyfeatureprovided by your new unit, the Owner's
Manual s hould readinits entirety. T hemanual s hould
Pleasenote that although a battery Wasincluded in your TU-70 when it was shipped from the
factory, it has not been connected.You will need to refer to the section"Changing the Battery," for
instructions on connecting the battery.
Copyright @2000BOSSCORPORATION All rights reserved.NOpart Of this publication may be
reproducedin any form without the written permissionof BOSSCORPORATION.
Panel Descriptions (see figs. 1 and 2)
• Toprevent m alfunction and/or d amage tospeakrs o rother d evices. always t urndown the
onall devices b efore makinganyconnections.
• Once theconnections harebeen completed, turnonptver toyourvarious d evices in theorder s rcified. Byturningondevices i n
thewrong order, y ourisktuusingmalfunction and/or d amage t ospeakers andotherdevices.
Power-an sequence T IJ-70 Speakers andotherdevices
• Alwaysmake sureto volumelevelturneddownMoreSwitching onpwer. Evertwith thevolume all the
may still henrsome sound
1. Power Switch (POWER)
This turns the power on/off. If the TU-70 is left untouchedfor morethan ten minutes, the power will be turned
off automatically ( AutoPowerOfo.Whenthe2,oranybuttonfrom5 through8hasbeen pressed, t hepowerwill
be turnedoff tenminutesafter thebuttonwaspressed last.Byturning on thepower while simultaneously
holdingdownbuttons5—8, you candefeat t heAuto Power O ff function. T henexttimethepower is turnedon,
Auto PowerOff Will onceagain be activated.
2. ught Button (LIGHT)
This switchesthe backlit on/off. The backlit will automaticallybe turned off in threeminutes. If Ehe Auto Power
Off function hasbeen deactivated at powerup, the Auto Backlit Off function will not work.
3. Liquid Crystal Indicators
3-1. This indicatesthe mode (guitar/bass mode, auto/manual mode).
3-2.Thisgraphically indicates thestringnumberandstringposition.
3-3. This indicatesthe referencepitch. The referencepitch is the frequencyOfthe A4 note (middle A on a piano)
O
ontheinstrument ( suchasapiano)thatwill providethetonal f ocusof aperfo
34. This indicatesthe tuning mode.
3-5. Meter:This indicatesthe differencebetweentheinput pitch andthe correctpitch of the indicatedstring number.
4. Tuning Guide Indicators (TUNINGGUIDE)
liélts to indicate the approximate tuning.
lit Pitch is too low lit: Pitch is too high
Thetuningguidewill light within a range of +/ -3cents.
5. Auto Button (AUTO)
In Automode, t hisselects guitarorbassmodes. I n Automode, t hestringnumberis displayedautomatically for
the input sound. Normally you will tune in Auto mode.
6. Manual Button (MANUAL)
In Manualmode, this specifies the string that you wish to tune. [n Manual mode, you must first speci.9the string
name thatyou wish to tune.Thisis useful f or tuningwhenyouhavechanged stringsorwhenyou havechanged
modes.First use the Auto button to *lect guitar/bass mode.
7. Tuning Mode Select Button (MODE)
This selectsthe timing mode. In Guitar made, pressing the Mode button cycles you through the settings as
follows: F lat(b) — Doubleflat (
In Bassmode, it cyclesyou through the following ættings:Flat (b) —Doubleflat (
8. Pitch Button (PITCH)
Thisadjuststhe referencepitch. Whenyou pressthe Pitch button Once, t he indicator showing the currentreference
pitch(3-3) w ill blinkforapproximately t woseconds. Whileit isblinking, y oucanpress thePitchbuttononceagain
tochange thereference p itch in 1Hz steps. P ress t hePitch buttonrepeatedly u ntil youobtainthedesired reference
pitch. reference p itchcanbesetto anyfrequency f rom435to46 Hz (1Hzsteps). m ten thepoweris turned
off, the referencepitch you setwill be resetto 440Hz.
(33)
9. Input Jack (INPUT)
Connectthe guitar/bass that you wish to tune to this jack
10. Output Jack (OUTPUT)
Thesignal O ftheustrumentconnected to theinputjackis Output f romthisjack.
11. Internal Microphone
Usethis when tuning an acoustic instrument. Play the instrument nearthe intemal mic- When using the internal
mic to tune, do not plug anything into the input jack
Memory functions of the TU-70 (Thefollowing settings are remembered.)
Whilethepowerison - Thestringnumber y ou selected i n each mode; G uitarandBass (Manual m ode)
- The tuning mode for eachmode;Guitar and Bass(Auto/Manual modes)
- Guitar [Bass mode
While the power is off
• When youreplace t hetuttery,thestored mode is cleared, and
12
01--a—ZY5
446Hz (IHzXü) : AO (27.5Hz)
: 4'?OkQ so—lb:
F • -f YYY—5— :
(9V) 13mA
(l a 10
190B
(A4=440H2 xn),
x 53 x 35.3 : 1609
(911).
Owner's Manual
"USING THE UNIT SAFELY" and "IMPORTANT
andkeptonhandasaconvenient reference.
the is switched on,butthis is anddoes
and both lit: Pitch is correct
) — OpenD — OpenE— Open G— OpenA— Regular.
) — Regular.
(MIC)
bereset t o
— C8 (4186.0HZ)
•
•
, 27mA
: b 120 a
: %
andturnoffthepower
down,
a
settings (Guitar,Automode).