Burchda R5 Benutzerhandbuch Seite 3

2
1. Install handlebar riser 2. Adjust the nut position
4. Adjust the center position of the 5. Tighten the left and right nuts as
tire so that the positions on both shown
sides are the same.
7. Connect the light wires (note that 8. Install the fender bracket screws
the arrows at both ends of the
wiring correspond)
3. Install the front fork on the front
wheel bearing
6. Install the lights and fenders,
9. Take out the pedal with the letters
"R" and "L", align it with the crank
hole and lock it with a wrench