Assembly And Installation Instructions; Charging The Battery; Replacing Battery - Hortensus Ec11045 Bedienungsanleitung

ASSEMBLY AND INSTALLATION INSTRUCTIONS:

No tools required for assembly and installation.
FOR FIRST TIME USE : Remove the pull tap between the top cover
(1) and housing(3). (Fig. 1)
1. Insert the housing (3) into the top cover (1) and twist to lock. (Fig. 2)
2. Firmly slide post (4) into housing (3).
Attach the post (4) to stake (5). Push the stake(5) firmly into the ground
- DO NOT use a hammer. For ground with hard soil , to prevent breaking the
stake (5), use trowel to loosen soil first. (Fig. 3)

CHARGING THE BATTERY:

For optimum performance, it is best to install the solar lights in full
sunlight and charge for 10-12 hours. Allow the light to run at least
8-12 entire charging and discharging cycles to reach battery's maximum
capacity.
TROUBLESHOOTING:
Possible Cause
The nightly run time is 1. Battery is not fully
shorter. charged.
2. Battery is reaching the
end of its useful life.
Solar light is installed
Solar light does not turn
on at night. close to other light sources.
1

REPLACING BATTERY:

3
For best performance, replace with rechargable 1.2V AAA battery when
Fig.4
performance diminishes.
1. Twist and remove the housing (3) from top cover (1).(Fig.4)
2
2. Replace the old battery with a fresh 1.2V AAA rechargeable battery.
Replace the housing.(Fig.5)
Fig.5
Corrective Action
1. Locate the solar light in an
area where it can receive the
maximum amount of full,
direct sunlight everyday.
2. Replace the old battery
with a fresh one.
1. Relocate the solar light.
2. Eliminate
sources.
CAUTION:
BATTERY MUST BE RECYCLED OR DISPOSED
OF PROPERLY.BATTERY MUST BE FAR AWAY
FROM FIRE.
other light
1
Fig.1
1
3
Fig.2
3
4
5
Fig.3
Page 2