Tarmo 320921 Schnellstartanleitung

EN REMOTE-CONTROLLED SOCKETS
Read and follow all the user instructions carefully. The re-
mote control receiver is used to switch electrical devices
and lamps wirelessly on and off.
Instructions for use
The following devices may not be connected to the remote
control receiver:
- devices that do not comply with the technical data of the
remote control receiver
- devices with condenser units (e.g. a refrigerator)
- devices that can cause a fire or other damage when in-
advertently switched on (e.g. a clothes iron).
Technical specifications
Rated voltage: max. 16 A 3680 W
Maximum permitted load: 16 A 3680 W
Radio frequency: 433.92 MHz
Range (under ideal conditions): max. 50 m
Remote control: 3 V CR2032 battery (1 x), IP20
Receivers: IP44
Safety instructions
- Remote control receivers can only be connected to a
properly installed earthed outlet (230 V/50 Hz).
- Do not connect the wireless remote control receivers in
series.
- Do not make any alterations to the device. Incorrect as-
sembly may cause an electric shock, a short circuit or a
fire hazard.
- The range of the remote control may be disrupted by
structures (e.g. reinforced concrete) or sources of electri-
cal/electromagnetic interference (e.g. fluorescent lamps,
mobile phones, televisions and electrical wires). If neces-
sary, remove the source of interference or keep a suffi-
cient distance from the source.
- Avoid moisture and extreme temperatures, vibration and
shaking.
- Clean with a soft, damp cloth. Do not use solvents. Do
not immerse in water.
- De-energised only when unplugged.
- Do not insert needles or other metallic objects into the
power outlet.
- Risk of electric shock! Although the product is splash-
proof (IP44), do not use it near water or other liquids, or in
places where water or other liquids may accumulate. Nev-
er immerse it in water. Protect the power plug from mois-
ture.
- When using outdoors, connect the device to an IP44-rat-
ed (or higher) power outlet.
- Make sure that the devices that are connected to the
product are IP44 rated.
- Close the protective cover when the product is not in
use.
Operation – programming the remote control
- The remote control can be programmed so that the con-
320921_kauko-ohjattavat_pistorasiat_ko_EN-FI-SV-DK-NO-ET-LV-LT-DE-PL.indd 1 320921_kauko-ohjattavat_pistorasiat_ko_EN-FI-SV-DK-NO-ET-LV-LT-DE-PL.indd 1
Tammer Brands Oy, Viinikankatu 36, 33800 Tampere, Finland
nected receiver can be switched on and off.
- Connect one of the remote control receivers to the
earthed outlet you have selected.
- Press and hold down the receiver button for 3 seconds.
The blue LED indicator light flashes slowly.
- Then press the number button on the remote control to
set the receiver to this number position (1, 2, 3; left-hand
side buttons). When the receiver emits a signal tone 2
times, the programming has been completed successfully.
- You can now use the left-hand side buttons to switch on
the receiver and the right-hand side buttons to switch it
off. Press the G button to switch all programmed receiv-
ers on or off.
- Battery installation: Open the battery compartment cov-
er. Insert one CR2032 button cell into the battery compart-
ment, according to its correct polarity. Replace the battery
compartment cover.
Deleting programming
Option 1
- Press the receiver button for 3 seconds. The blue LED in-
dicator light flashes slowly.
- Press the OFF button on the remote control for about 3
seconds to delete the programming.
- The receiver sends a signal tone 2 times. The connected
device switches on and off 2 times.
- Now you can start programming from scratch.
Option 2
- Press the receiver button for 3 seconds. The blue LED in-
dicator light flashes slowly.
- Press the receiver button once.
- The receiver sends a signal tone 2 times. The connected
device switches on and off 2 times.
- Now you can start programming from scratch.
Declaration of Conformity
Hereby, Tarmo declares that the radio equipment type
320921 REMOTE-CONTROLLED SOCKETS is in compliance
with Directive 2014/53/EU. The full text of the EU declara-
tion of conformity is available at the following internet ad-
dress: tammerbrands.eu/id/320921
Disposal
Do not dispose of the device with household waste. The
device must be disposed of at a designated collection
point for appropriate further processing. Ask your local
waste facility for more information.
320921
ko0124
Info/Tootja/Ražotājs/Gamintojas:
IP44
25.1.2024 14.50.44 25.1.2024 14.50.44