TeleAlarm LE10 Bedienungsanleitung Seite 34

34 en | Product information
Mode Name
4 Dementia with
Accompany
5 Remote control
6 Open receiver
7 Open receiver with
reduced range
8 Extended N46
transmitter
programming (from
SW 1.10 on)
9 Dual channel
receiver (from SW
1.10 on)
NOTICE!
Factory setting is normal mode 1, in which 20 wireless
transmitters can be programmed. Calls are indicated by the red
LED and Relay 1. A battery-low signal is indicated by the red
LED and Relay 2.
F.01U.139.675 | V1.5 | 2015.10
Description
This mode allows the LE10 Radio Receiver to
be connected to a wired NurseCall system, in
which the Accompany function can be
implemented. It will wait 10 seconds after
receiving a signal from an S37L transmitter. If
it detects an S37E transmitter in this lapse of
time, then no alarm is generated. If not, then
Relay 1 is activated for 2 seconds.
20 wireless transmitters can be programmed.
Per sequence, only the same transmitter can
switch on and off the Relay1. A battery-low
signal is indicated by LED 2 and Relay 2.
No wireless transmitter needs to be
programmed. Any transmitter within reception
range of the LE10 Radio Receiver can activate
the device.
Same functions as in mode 6, but with
reduced range. This functionality is designed
to improve reception of transmitters located
closer to the LE10 Radio Receiver.
Additional N46 transmitters can be
programmed. Behavior is similar to normal
mode 1, with certain differences according to
the transmitter that is activated.
Only S37 wireless transmitters can be
programmed. Calls are indicated by Relay 1 or
Relay 2, according to the slot in which the S37
wireless transmitter is programmed. A battery-
low signal is indicated by the red LED.
User Manual
LE10 Radio Receiver
TeleAlarm