CAPTELEC QUICK FIX Bedienungsanleitung Seite 4

A 0203 / XXX
Warning: Please read this instruction manual carefully before using the instrument and keep it for future use.
1.Squeeze cover at three dots and slide off to reveal
storage compartment.
2. Place accessories into storage compartment. Press hoods onto
pegs as shown. Insert caps into recessed areas on either side of the
compartment. Peg strips must be inserted at an angle, point first
toward the bottom edge, then press until it snaps into place.
Do not direct towards people. Keep out of reach of children. Wear protective glasses
Do not place any part of this appliance in water or any other liquid. Keep it away from heat sources such as radiators, to avoid deformation of plastic parts. Do not use coarse or
abrasive sponges/cloths or steel wool to clean the appliance.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capacities, or by persons lacking in experience or knowledge, unless
they are supervised or instructed on the use of this apparatus by a person responsible for their safety.Children should be supervised to ensure they do not play with this appliance.
Importé par / Importiert von / Geïmporteerd door / Imported by CAPTELEC, 59170 Croix - FRANCE
STAPLE GUN
3. To load peg strip for use, turn spring loaded and cap 3. Pour charger la bande de clous à utiliser, tournez le capuchon
counterclokwise to remove, and slide remaining peg strip into the d'extrémité à ressort dans le sens inverse des aiguilles d'une montre
compartment. Peg strip must be angled in the same direction as the pour le retirer ; et glissez la bande de clous dans le compartiment. En
peg icon at the end of the device. vous assurant qu'ils sont inclinés dans la même direction que l'icône
4. Replace end cap and turn it clockwise to lock into place.
5. Place the tool flush against wall and use bubble
level to adjust for straightness. Push down forcefully
on grey button to dispense peg into wall.
6. To remove a peg from the wall, line the removal notch up
with the peg and pull away from the wall.
EN