Jdash1: Tuning Controller Connector; Ez Debug Led - Toshiba Ac25Cew-Ssc Bedienungsanleitung

JDASH1: Tuning controller Connector

This connector is used to connect an optional Tuning Controller module.
2 6
1 5

EZ Debug LED

These LEDs indicate the status of the motherboard.
CPU - indicates CPU is not detected or fail.
DRAM - indicates DRAM is not detected or fail.
VGA - indicates GPU is not detected or fail.
BOOT - indicates booting device is not detected or fail.
Pin Signal Name
1 No Pin
3 MCU_SMB_SCL_M
5 VCC5
25
Pin Signal Name
2 NC
4 MCU_SMB_SDA_M
6 Ground