Jet-Line VILLA ROMA Bedienungsanleitung Seite 14

Usage
1. Switch on your whirlpool / connect the power supply
2. Turn on the cold/warm water switch and adjust to the suitable temperature.
Use the switch to choose between faucet and handheld shower for water inlet
3. Do not start the water pump unless the water level in your bathtub reaches all jets
4. Use the air regulator to adjust the requested intensity oft he massage jets
5. Rotate the top of the handheld shower to choose to the requested stream
6. Use the light switch to tun the underwater light on or off
7. Press the pneumatic switch in ordert o turn off the pump and drain the water after use
8. Switch off your whirlpool / disconnect the power supply
Troubleshooting
Problem
The water pump does not work
The air pump does not work
The intensity of the massage
power cannot be adjusted
The bathtub does not stand even
Water leakage
Possible Reason
Power supply is not connected
or leakage protector is
disconnected
Water pump impeller is stuck by
sundries
Water pump switch is off
Power supply plug is not inserted
correctly or the power supply is
insufficient
Water pump is defect
Power supply is insufficient
Air pump switch is off
Power supply plug is not
connected
Voltage problem
Adjust switch is off or defect
Water circulation is blocked
Adjustable foot is not well-
adjusted
Obturating ring is no good
Nut is loose
Connecting part is loose
Possible Solution
Turn on power supply and
connect leakage protector
Clean water pump impeller
Press water pump switch
Plug in power supply
Repair or replace water pump
Check circuitry and plug in power
supply
Press the air pump switch
Plug in power supply
Check voltage
Check (and if required replace)
switch
Clean the water circulation
Adjust feet to level out floor
bumps
Replace obturating ring
Fix nut screwing
Check and fasten connecting
parts
14