Sybility Easy SP-Switch Schnellstartanleitung Seite 2

www.sybility.de
Easy SP-Switch
The Easy SP-Switch uses the ELDAT Built-In Transmitter RTS03.
When puffing into the hose an Easywave signal code A is sent and the
3.5 mm connector 1 (mono) is switched.
Sipping on the hose will send an Easywave signal code B and also switch
the 3.5 mm connector (mono).
The signal will be sent as long as you sip or puff into the hose, but max
time is 36 seconds.
On each side you can adjust the sip and puff strength. Use a small screw
driver and turn to + direction to increase the strength and – direction to
decrease the strength.
Attention: Too much in – direction will lead to continuously sending.
You can also connect a switch to the 3.5 mm connectors and send the
Easywave signals by pressing the switch.
Battery Replacement:
Release the 4 screws and open the plastic case by removing the cover.
You can easily see the battery on the transmitter module and exchange
Please watch the right polarity when placing the battery back in!
Close the plastic case again.
The transmitter uses a battery type CR2032.
Please see also the included manual of the transmitter module.
For any questions please contact your local dealer or:
Sybility GmbH, Kreuzweg 15, D - 91781 Weißenburg
Tel. +49 (0) 9141 91 31 689
Email: info@sybility.de
Easy SP-Switch
it.
12/2019
www.sybility.de
Easy SP-Switch
The Easy SP-Switch uses the ELDAT Built-In Transmitter RTS03.
When puffing into the hose an Easywave signal code A is sent and the
3.5 mm connector 1 (mono) is switched.
Sipping on the hose will send an Easywave signal code B and also switch
the 3.5 mm connector (mono).
The signal will be sent as long as you sip or puff into the hose, but max
time is 36 seconds.
On each side you can adjust the sip and puff strength. Use a small screw
driver and turn to + direction to increase the strength and – direction to
decrease the strength.
Attention: Too much in – direction will lead to continuously sending.
You can also connect a switch to the 3.5 mm connectors and send the
Easywave signals by pressing the switch.
Battery Replacement:
Release the 4 screws and open the plastic case by removing the cover.
You can easily see the battery on the transmitter module and exchange
Please watch the right polarity when placing the battery back in!
Close the plastic case again.
The transmitter uses a battery type CR2032.
Please see also the included manual of the transmitter module.
For any questions please contact your local dealer or:
Sybility GmbH, Kreuzweg 15, D - 91781 Weißenburg
Tel. +49 (0) 9141 91 31 689
Email: info@sybility.de
Easy SP-Switch
it.
12/2019