Creality CV-Laser Module Benutzerhandbuch Seite 22

User operation guide
FDM -> Laser Engraving
Start
Heat and remove the
unconsumed filaments
Disconnect the power
supply
Unplug the cable
Remove the Hotend Kit
Installing the fixing plate
of the Laser Module
Installing the Laser
Module
Plug in the cable of the Laser
Module
Turn on the supply power and
the Laser Module Switch
Select the Laser
Engraving
Place engraving materiál and
adjust laser module focus
Select engraving file
The module will automatically start Run
Range and adjust position based on the
material
Start Engraving
22
End