RUSTA 900701420101 Handbuch Seite 7

TROUBLESHOOTING
PROBLEM
"ADD WATER" indicator
turns on
"ICE FULL" indicator
lights up
The ice collects together.
The ice-making cycle
seems normal but no ice is
produced.
Poor ice-making result
POSSIBLE CAUSES
1. Low water level or lack
of water.
2. The water screen at the
bottom of water reservoir
is blocked.
3. Pump malfunction.
1. Ice basket is full and the
infrared light is blocked
by the ice.
2. Infrared light-emitting
diode & light-receiving
diode do not work.
Making ice takes too much
time.
The water in the water reser-
voir is of too low temperature.
The ambient temperature or
water temperature is
too high.
1. Poor heat dissipation.
2. The water temperature is
too high.
3. The ambient temperature
is too high.
SOLUTION
1. Stop making ice, refill water
and then press "ON/OFF" key
to restart ice-making cycle.
2. Do cleaning.
3. Send it to the authorized
department for repair.
1. Remove the ice from
ice basket.
2. Wipe up the foreign objects
on the infrared light-emitting
diode & light-receiving diode
and restart the ice maker.
Stop making ice and restart
the ice-making cycle after the
ice melts.
Fill the water reservoir with
water ranges between 8 ℃ and
25 ℃.
Start the ice-making cycle at a
environment with an ambient
temperature less than 32 °C and
fill the water reservoir with some
cold water.
1. Leave a 6-inch clearance on
all sides of the ice maker for
proper ventilation.
2. Fill the water reservoir with
water ranges between 8 ℃
and 28 ℃.
3. Operate the ice maker at a
environment with an ambient
temperature between 10 ℃
and 32 ℃.
7