Perry Electric 1TX RX0801/P Benutzerhandbuch Seite 4

GB
1 - INSTRUCTIONS FOR THE INSTALLER
1.1 - INSTRUCTIONS AND REQUIREMENTS FOR INSTALLING THE RECEIVER
Install the receiver at a height that allows the antenna to stick up above any nearby metal container (boiler, expansion tanks, metal
cabinets); avoid positioning the antenna near cables and electrical panels (fig. 2.i).
Cabinets, walls and slabs containing metal can limit the operation of the product.
This system is incompatible with radio products working on the same frequency (868,35 MHz) using a
permanent emission mode.
Important: installation and electrical connections of devices and appliances must be carried out by skilled people and in
compliance with current regulations. The manufacturer declines any liability in connection with the use of products subject to
special environmental and/or installation standards. Examples given in the manual are purely indicative.
Instructions relative to the structure of realizable systems and the assignment of areas to individual chronothermostats
or thermostats are shown in the technical documentation for the transmitter devices (chronothermostats and/or
thermostats).
ON RADIO
RECEIVER
1 2 3 4 5 6 7 8 RESET
BUS + RX
230 V
!
Install the control box as instructed in its own manual.
!
Install the 8 zone receiver as instructed below.
1.2 - INSTALLING THE BASE ON THE WALL
Installing the device: INDEPENDENT - FIXED
WARNING! DISCONNECT MAINS POWER FROM THE CONTROL BOX
BEFORE INSTALLING THE RECEIVER.
For installation, it is necessary to separate the front part, complete with
electronic card, from the base.
!
First on one side and then on the other, insert a screwdriver in the slots located
on the sides of the product, exerting light pressure on the locking catch, then,
with a small forward rotation of the screwdriver (as shown in figure 3.i), lift the
front.
!
Remove the front from the base (the resistance to removal is due to the
coupling pin on the terminal strip) (fig. 4.i).
From the base, remove the parts prepared for the passage of the connection wires shown in fig. 5.i.
!
Pass the connection wires through the opening you have made.
!
Attach the base to the wall (or built-in box), with 2 screws using the pairs of holes (
!
Make the electrical connections to the terminals located on the base as shown in the next chapter.
D = Catches for locking
the front to the base
Removable area for the
passage of wires (Installation
with built-in box)
INSTALLATION
CONTROL BOX
SOLENOID VALVES
C B A A B C
D
PUMP
A-A, B-B, -C-C
D
Removable areas for
installation with trunking
system
4
ON
OK
RESET
ON
NO
RESET
Fig. 2.i
ON
1 2 3 4 5 6 7 8
RESET
Fig. 3.i
ON
1 2 3 4 5 6 7 8
RESET
Fig. 4.i
) provided (fig. 5.i).
Fig. 5.i